User Manual DDS200 Digital Demodulation System 070-9952-00

Appendix A: SpecificationsTable A–2: Certifications and compliancesEC Declaration of Conformity –EMCEMC ComplianceFCC ComplianceEC Declaration of Conformity –Low VoltageApprovalsInstallation Category DescriptionsMeets intent of Directive 89/336/EEC for Electromagnetic Compatibility. Compliance wasdemonstrated to the following specifications as listed in the Official Journal of the EuropeanCommunities:EN 55011Class A Radiated and Conducted EmissionsEN 55011Class B Radiated and Conducted EmissionsEN 50081-1 Emissions:EN 55022 Class B Radiated and Conducted EmissionsEN 60555-2 AC Power Line Harmonic EmissionsEN 50082-1 Immunity:IEC 801-2 Electrostatic Discharge ImmunityIEC 801-3 RF Electromagnetic Field ImmunityIEC 801-4 Electrical Fast Transient/Burst ImmunityIEC 801-5 Power Line Surge ImmunityMeets the intent of Directive 89/336/EEC—Amended by 91/263/EEC, 92/31/EEC, 93/68/EEC— forElectromagnetic Compatibility when it is used with the product(s) stated in the specifications table.Refer to the EMC specification published for the stated products. May not meet the intent of theDirective if used with other products.Emissions comply with FCC Code of Federal Regulations 47, Part 15, Subpart B, Class A LimitsCompliance was demonstrated to the following specification as listed in the Official Journal of theEuropean Communities:Low Voltage Directive 73/23/EEC, Amended by 93/68/EECEN 61010-1:1993 Safety requirements for electrical equipment for measurement,control, and laboratory useUL3111-1 – Standard for electrical measuring and test equipmentCAN/CSA C22.2 No. 1010.1 – Safety requirements for electrical equipment for measurement,control and laboratory useTerminals on this product may have different installation category designations. The installationcategories are:CAT III Distribution-level mains (usually permanently connected). Equipment at this level istypically in a fixed industrial locationCAT II Local-level mains (wall sockets). Equipment at this level includes appliances, portabletools, and similar products. Equipment is usually cord-connectedCAT I Secondary (signal level) or battery operated circuits of electronic equipmentA–4 DDS200 Digital Demodulation System User Manual