TM-U295/U295P

[Reference]
ESC c 4, ESC c5
ESC t n
[Name] Select character code table
[Format] ASCII ESC t n
Hex 1B 74 n
Decimal 27 116 n
[Range] 0 ≤ n ≤ 2
[Description] Selects a page n from the character code table.
n
Page
0 0 (PC437 [U.S.A., Standard Europe])
1 1 (Katakana)
2 2 (PC850 [Multilingual])
[Note] If n is outside the specified range, the printer ignores this command.
[Default] n = 0
ESC u n
[Name] Transmit peripheral device status
[Format] ASCII ESC u n
Hex 1B 75 n
Decimal 27 117 n
[Range] n = 0, 48
[Description] Transmits the status of connector pin n upon receiving this
command, using n as follows:
n
Connector pin
0, 48 Drawer kick-out connector pin 3
[Notes] • When the connector is not used, the value of bit 0 is always 1.
• When DTR/DSR control is selected, the printer transmits only 1
byte after confirming that the host is ready to receive data (DSR
signal is SPACE). If the host computer is not ready to receive data
(DSR signal is MARK), the printer keeps waiting until the host is
ready. When XON/XOFF control is selected, the printer transmits
only 1 byte without checking the DSR signal.
• This command is executed when the data is processed in the
receive buffer. Therefore, there may be a time lag between
receiving the command and transmitting the status, depending on
the receive buffer status.
5-24 Commands