Multipactor in Low Pressure Gas and in ... - of Richard Udiljak

Recommendations

Info

Paper F V. E. Semenov, N. Zharova, R. Udiljak, D. Anderson, M. Lisak, and J. Puech, “Multipactor in a coaxial transmission line, part II: Particlein-Cell simulations”, accepted for publication in Phys. Plasmas
Page 1 and 2:
Thesis for the degree of Doctor of
Page 3:
Multipactor in Low Pressure Gas and
Page 6 and 7:
Conference contributions by the aut
Page 8 and 9:
viii
Page 10 and 11:
3.2.4 Key findings . . . . . . . .
Page 12 and 13:
xii
Page 14 and 15:
xiv
Page 16 and 17:
addition, it is difficult to make c
Page 18 and 19:
numerical study of the phenomenon i
Page 20 and 21:
to physically damage microwave comp
Page 22 and 23:
odd positive integer (N = 1,3,5...)
Page 24 and 25:
σ se [−] 2.5 2 1.5 1 0.5 W 1 W m
Page 26 and 27:
Voltage [V] 10 4 10 3 10 2 10 0 N=1
Page 28 and 29:
even though it may be sufficient fr
Page 30 and 31:
where φL and φR are the left and
Page 32 and 33:
(cf. Fig. 2.7). When taking the env
Page 34 and 35:
2.1.4 Methods of suppression Many o
Page 36 and 37:
Noise (dBm) Power #1 (dBm) Match #1
Page 38 and 39:
andom spread in emission velocities
Page 40 and 41:
Figure 2.12: Multipactor experiment
Page 42 and 43:
where kn is a factor determining th
Page 44 and 45:
allows for another design margin, w
Page 46 and 47:
Boundary function Method One of the
Page 48 and 49:
carriers, because the NLSQ method r
Page 50 and 51:
multipactor discharge. Using a Mont
Page 52 and 53:
the assumption of a constant ratio
Page 54 and 55:
Voltage (V) 10 3 10 2 10 1 10 −2
Page 56 and 57:
3.1.3 Main results The main result
Page 58 and 59:
lytical model is obviously needed.
Page 60 and 61:
where 〈vt 2 〉 represents the av
Page 62 and 63:
these quantities in the range from
Page 64 and 65:
analytical. Attempts were made to f
Page 66 and 67:
only model, the inclusion of ionisa
Page 68 and 69:
Normalised Voltage 1.1 1.05 1 0.95
Page 70 and 71:
Voltage [V] 10 3 10 0 µ=0 µ=0.75
Page 73 and 74:
Chapter 4 Multipactor in irises A c
Page 75 and 76:
h l Figure 4.1: The geometry used i
Page 77 and 78:
N e /N 0 [−] 3 2.5 2 1.5 1 Multip
Page 79 and 80:
to compensate for electron losses i
Page 81:
4.4 Main results This analysis has
Page 84 and 85:
support for the qualitative analyti
Page 86 and 87:
where R(t) is the average position,
Page 88 and 89:
where d stands for the gap width, V
Page 90 and 91:
there are different oscillatory vel
Page 92 and 93:
Phase [degrees] 60 50 40 30 20 10
Page 94 and 95:
G 100 90 80 70 60 50 40 30 20 10 0
Page 96 and 97:
possible for quite large Ro/Ri-valu
Page 98 and 99: upper right region of the figures,
Page 100 and 101: σse,max the zones become wider and
Page 102 and 103: G 50 45 40 35 30 25 20 15 10 5 0.2
Page 104 and 105: creasing ratio Ri/Ro was observed.
Page 107 and 108: Chapter 6 Detection of multipactor
Page 109 and 110: Amplitude of acceleration [Gm/s 2 ]
Page 111 and 112: tipactor events that are short-live
Page 113 and 114: software and the time evolution of
Page 115 and 116: ditional test sample, a resonant ca
Page 117 and 118: the FFT. It was concluded that ther
Page 119 and 120: 6.2.1 Single carrier When using the
Page 121 and 122: Reference signal generator Phase co
Page 123 and 124: Amplitude [A.U.] 2.5 2 1.5 1 0.5 De
Page 125 and 126: Chapter 7 Conclusions and outlook T
Page 127 and 128: tioned there were multipactor in no
Page 129 and 130: References [1] W. Henneberg, R. Ort
Page 131 and 132: [27] A. Ruiz et al, “Ti, V, and C
Page 133 and 134: [51] D. Wolk, D. Schmitt, and T. Sc
Page 135 and 136: [75] R. Udiljak, Multipactor in low
Page 137: Included papers A-F 123
Page 141: Paper B R. Udiljak, D. Anderson, M.
Page 145: Paper D R. Udiljak, D. Anderson, M.
show all

Multipactor in Low Pressure Gas and in ... - of Richard Udiljak

Create successful ePaper yourself

Delete template?

Save as template?