Adabas Transaction Manager Messages and Codes - Software AG ...

Action
Response 22
Origin
Subcode
8
9
249
(0x00F9)
Meaning
The command ID value specified for the S8 command is for an unsorted ISN list.;
the ISN list was not in ISN sequence.
An application running with PREFETCH=YES or PREFETCH=OLD attempted
to dynamically reverse the read direction of an L3/L6/L9 command. This is not
allowed.
An invalid command ID value was detected by Adabas Vista (open systems):
■ The command ID value specified with the N option of an L1/L4 command
was not found.
■ The command ID value specified with the N option of an L1/L4 command
does not correspond to an ISN list.
■ One or both of the ISN lists referred to in the ADDITIONS 1 field of an S8
command do not exist.
Action: Review the program logic.
Correct the command ID.
Mainframe and open systems
Explanation The command or command option is invalid. A subcode indicating the specific cause and
action for this response code appears in the low-order (rightmost) two bytes of the ACB's
Additions 2 field or in the ACBX's Error Subcode (ACBXERRC) field.
When using the LNCSTUB module on mainframe systems, this response code may indicate
problems with the initial call (IC) to the Adabas CICS command-level link component. If the
Adabas control block shows a command code of "IC", the link routine being used may not be
at the proper release level or may not be the command-level version.
The following are the subcodes and their meanings:
Subcode Meaning
1
2
3
4
5
6
7
The nucleus detected an invalid command code.
This command cannot be issued by an ACC (access only) user; and update command
cannot be issued by an access-only user.
This command cannot be performed on a read-only nucleus; an update command
cannot be issued for a read-only database session.
This privileged command was issued without a previous OP (open) command.
The command is not valid for a nonprivileged user.
The command was rejected by user exit 1. In this case, the first two bytes of the
Additions 2 field contain the response code of the user exit.
Incorrect command options were specified for a privileged command.
Adabas Transaction Manager Messages and Codes
Adabas Response Codes
63