ZIRCONIA OXYGEN PROBE OUTPUT (mV) - Novatech Controls

SET-UP MODE SUMMARY
5.1 SET-UP MODE FUNCTIONS
1. Sensor Type
2. Probe Thermocouple Type
3. Flue Thermocouple Type
4. Transmitter Output Channel 1
5. Transmitter Span Channel 1
6. Transmitter Output Channel 2
7. Transmitter Zero Channel 2
8. Transmitter Span Channel 2
9. Centigrade/Fahrenheit Selection
10. Lower Line Display Functions
11. Flue Pressure mm/inches/kilopascals
12. Flue Pressure Value
Set-up steps 13 to 27 will be skipped automatically if efficiency or oxygen deficiency are not selected in steps 6,
10 or 46.
13. Single or Dual Fuel
14. Type of Fuel #1
15. Fuel #1 ‘A’ Value
16. Fuel #1 ‘H’ Value
17. Fuel #1 ‘O’ Value
18. Fuel #1 ‘N’ Value
19. Fuel #1 ‘S’ Value
20. Fuel #1 ‘M’ Value
Set-up steps 21 to 27 will be skipped automatically if ‘Single Fuel’ is selected in set-up step 13. 21. Type of Fuel #2
22. Fuel #2 ‘A’ Value
23. Fuel #2 ‘H’ Value
24. Fuel #2 ‘O’ Value
25. Fuel #2 ‘N’ Value
26. Fuel #2 ‘S’ Value
27. Fuel #2 ‘M’ Value
28. Purge/Cal Time
29. Automatic Purge
Set-up steps 30 to 32 will be skipped automatically if ‘No’ is selected in set-up step 29.
30. Time Between Purges
31. Purge Duration
32. Purge Freeze Time
33. Number of Cal Gases
Set-up steps 34 to 45 may be skipped automatically, depending on the selection in set up step 33.
34. Oxygen Content of Cal Gas 1
35. Maximum Acceptable Positive Error Gas 1
36. Maximum Acceptable Negative Error Gas 1
37 Period Between Gas 1 Autocals
38. Duration of Autocal Gas 1
39. Freeze Time Gas 1
40. Oxygen Content Of Cal Gas 2
41. Maximum Acceptable Positive Error Gas 2
42. Maximum Acceptable Negative Error Gas 2
43. Period Between Gas 2 Autocals
44. Duration of Autocal Gas 2
45. Freeze Time Gas 2
46. Data to Print
47. Print Log Period
48. Printer Baud Rate
49. Relative Humidity Sensor Connected
50. Switched Reference Air Supply
51. Damping Factor
NOVATECH OXYGEN ANALYSER 5.1