Views
4 months ago

V27 Software Guide Pulpmatic Ultima Eco Uno Incomatic V1.7

The “Outputs” menu

The “Outputs” menu shows the current state of each output and is read from the position of the relay assigned for each output on the PCB. (Not applicable for any models of Uno). (Fig 9) 34 Lid locking solenoids (240V locks only) (Not used) O05 Vent (Breather solenoid valve) O13 Cold valve (Cold water valve) O04 Dose (Chemical dosing pump) O03 Pump (water pump) O02 Cutter motor (single phase) O02 Cutter motor (3 phase) (Fig 10) 34 Copyright © 2017 DDC Dolphin Ltd. Page 30 of 47 February 18 SGPv27 – V1.7

The “Other Analog” menu shows parameters that are not assigned at this time (Fig 11) 34 The “Settings” menu shows the machine parameters and there default settings. These settings and there default values are described further in Section 11 (Fig 12) 34 Note changes to the settings screen are not possiable through the monitor software. Adjustments to the parameters must be made through the use of the push buttonms located on the PCB. This process is described further in Section 11 Copyright © 2017 DDC Dolphin Ltd. Page 31 of 47 February 18 SGPv27 – V1.7

A Leader's Guide to Agile Business - Rally Software
Medical Office Software Guide
WinAlign® Software
License Administration Guide - Sonnet Software
Agile Development, DevOps and achieving ... - Rally Software
Geovision NVR Software Feature Guide - Use-IP
Product datasheet: Sony SNC-DH240T - Network Webcams
software validation - Pharsight Corporation
TerraExplorer Quick Start Guide - Skyline Software Systems
SNC-CH220 - Sony Professional Solutions Asia Pacific
Camera IP HD de tip bullet Sony SNC-CH160 - GTO Security ...
EtherLogic Ultima Controller - Industrial Control Links
Polycom UC Software Administrators' Guide
Polycom UC Software Administrators' Guide - 4.1.0
Polycom UC Software 4.0.1 Administrators' Guide