RSU-503 Redundancy Switch Unit Installation ... - Comtech EF Data

More documents

Recommendations

Info

Installation RSU-503 Redundancy Switch Unit 2.3 Switch Installation At the customer’s discretion, the switch can be installed anywhere on or near the antenna. The supplied hardware allows the installer a wide range of installation alternatives, including: • Vertical pole (e.g., mast) (either square or round). This is the most typical installation. • Within the hub of a large antenna. • Spar (i.e., rectangular bar) on the antenna structure. The switch is designed to be mounted with the interface connections facing the ground. Note: For custom installations, refer to Figure 2-1 for dimensions of the RSU-503. 4 Rev. 8
RSU-503 Redundancy Switch Unit Installation Note: All dimensions in inches. Figure 2-1. RSU-503 Dimensions Rev. 8 5
Page 1 and 2: RSU-503 RSU-503 RSU-503 Redundancy
Page 3 and 4: RSU-503 RSU-503 Copyright © Comtec
Page 5 and 6: About this Manual Preface This manu
Page 7 and 8: RSU-503 Redundancy Switch Unit Pref
Page 9 and 10: Table of Contents CHAPTER 1. INTROD
Page 11 and 12: RSU-503 Redundancy Switch Unit Tabl
Page 13 and 14: 1Chapter 1. INTRODUCTION This chapt
Page 15 and 16: RSU-503 Redundancy Switch Unit Intr
Page 17 and 18: 2 Chapter 2. INSTALLATION This chap
Page 19: RSU-503 Redundancy Switch Unit Inst
Page 23 and 24: RSU-503 Redundancy Switch Unit Inst
Page 43 and 44: Theory of Operation RSU-503 Redunda
Page 45 and 46: Theory of Operation RSU-503 Redunda
Page 47 and 48: Maintenance RSU-503 Redundancy Swit
Page 55 and 56: RSU-503L Option RSU-503 Redundancy
Page 63 and 64: Remote Control Operation RSU-503 Re
Page 71 and 72:
Glossary The following is a list of
Page 73 and 74:
RSU-503 Redundancy Switch Unit Inde
show all

RSU-503 Redundancy Switch Unit Installation ... - Comtech EF Data

Create successful ePaper yourself

Delete template?

Save as template?