RSU-503 Redundancy Switch Unit Installation ... - Comtech EF Data
RSU-503 Redundancy Switch Unit Installation ... - Comtech EF Data
RSU-503 Redundancy Switch Unit Installation ... - Comtech EF Data
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Installation</strong> <strong>RSU</strong>-<strong>503</strong> <strong>Redundancy</strong> <strong>Switch</strong> <strong>Unit</strong><br />
2.4.6.2 LNA Plate to Waveguide <strong>Switch</strong><br />
The following table outlines the pinouts of the LNA plate to Waveguide <strong>Switch</strong> cable.<br />
This cable is internal on the redundant LNA plate.<br />
Note: This pinout table may be helpful if an <strong>EF</strong><strong>Data</strong> Waveguide <strong>Switch</strong> is used.<br />
Name Pin # Function<br />
Command, Position 1 A +28V pulse for 500 milliseconds<br />
Command Common B Ground<br />
Command, Position 2 C +28V pulse for 500 milliseconds<br />
Indicator, Position 1 D Connects to Common when in position 1<br />
Indicator Common E Ground<br />
Indicator, Position 2 F Connects to Common when in position 2<br />
2.4.7 TX/RF Output (J11)<br />
The TX/RF Output connector is a 50Ω type N connector used to monitor the transmit<br />
output signal from the offline RFT. This connector is used to test the offline unit.<br />
2.4.8 TX/IF Input (J12)<br />
The TX/IF Input connector is a 50Ω TNC connector used to input the IF test signal to the<br />
offline RFT. This connector is used to test the offline unit.<br />
2.4.9 RX/IF Output (J13)<br />
The RX/IF Output connector is a 50Ω TNC connector used to monitor the IF output<br />
signal from the offline RFT. This connector is used to test the offline unit.<br />
2.4.10 TX/IF Input (J14)<br />
The TX/IF Input connector is a 50Ω TNC connector used to receive the IF uplink signal<br />
from the modem. The switch routes the signal to the online RFT for transmission.<br />
2.4.11 RX/IF Output (J15)<br />
The RX/IF Output connector is a 50Ω TNC connector used to provide the IF downlink<br />
signal to the modem (after the signal is picked up by the antenna and routed through the<br />
online LNA and RFT).<br />
20 Rev. 8