WaveLAN/PCMCIA User's guide - web server

Installation for Windows 95 & Windows NT
Preparing Driver Installation
Getting Started 3
Preparing Driver Installation 3
When installing a WaveLAN/PCMCIA Card you will typically
install:
● The WaveLAN Miniport Driver
● Network (client) Operating Software and protocols
● (optionally) The WaveMANAGER/CLIENT diagnostics
program (described on page 3-30).
Network Client software is included with the Windows 95 and
Windows NT installation software. Before you start the
installation you are advised to keep the Windows CD-ROM or
software diskettes at hand.
Note: If you are upgrading from an earlier version of the WaveLAN
Miniport driver, please read “Upgrading from earlier Driver
Versions” on page D-4 first.
As the Windows operating systems differ slightly (see “What
You Need to Know” on page 3-1) some of the screens pictured
in this chapter may look different from the actual display on
your screen. The parameter settings for your WaveLAN card
however will be similar for both Windows 95 and Windows
NT systems.
To install the WaveLAN/PCMCIA Card, proceed as follows:
1 Insert the WaveLAN/PCMCIA card into your computer.
2 Make sure the cable from the antenna module is properly
connected to the WaveLAN/PCMCIA Card.
3 Power up your computer.
When your computer system runs the Windows 95 Operating
System, the ‘Plug & Play’ functionality will detect your
WaveLAN/PCMCIA Card and pop-pup with a message
3-4 WaveLAN/PCMCIA User’s Guide