CS1000 Software Input Output Reference - BT Business

Prompt Response Comment Pack/Rel
Used for building ANI message if ANIC=NO
and DN of set is not allowed to be sent (CLS
DNAD).
Also used if ANIC=YES but the ANI entry
associated with the originator of the call is
not configured, and DN of set is not allowed
to be sent (CLS DNAD).
X Remove ANDN
ANDT (NO) YES Automatic Number Identification Dial Tone ani-1
ANFT Defines the ANI Failure Treatment option. cist-24
(CONT) Provide call to the required destination
FAIL Drop the call
ITDN Transfer call to the intercept DN defined by
the ITDN prompt
ANI2_CLID (NO) Optional ANI2 display for CLID
Prompted when M911_FORM is set to 2.
ANIC (NO) YES ANI Composing
Prompted for outgoing CIS route.
If ANIC=NO, old ANI composing is used: if
the originator of the call is a set, ANI
message consists of the CAC of the
originator + the LEC of the outgoing route +
the DN of the originator or the ANDN of the
outgoing CIS route, depending on the class
of service (DNAA/DNAD) of the set. If the
originator of the call is an incoming route, the
components of the ANI message are
retrieved from default ANI entries and/or
from the data block of the outgoing CIS
route.
If ANIC=YES, the following is done:
If no entry is associated with the calling set
(ANIE=0), then old ANI composing is used.
If an ANI entry is associated with the calling
set (ANIE has a non-zero value), but the
associated ANI entry is not configured, then
old ANI composing is used.
If an ANI entry is associated with the calling
set (ANIE has a non-zero value), and the
associated ANI entry is configured, then ANI
table is used for building the ANI message:
none of the components of the ANI message
Alphabetical list of prompts
m911-7.00
cist-24
Nortel Communication Server 1000 April 2011 403