CS1000 Software Input Output Reference - BT Business

LD 16: Route Data Block, Automatic Trunk Maintenance
Prompt Response Comment Pack/Rel
Prompted when DTRK = YES, ISDN = YES
and Mode = PRA.
CISR (NO) YES CIS Route. cist-24
CLEN 0 - (1)- 3999 CLID entry number. esa-23
This prompt is given only for non-ISDN
routes (where ISDN = NO and ISAR = NO).
1 - (10) - 16 Maximum number of Calling Number
Identification digits to request for India
Phase 2 feature.
CLK (OFF) External Clock source basic-18
ON Internal Clock source
Prompted if TKTP = MCU and TRAN = SYN
CLS Class of Service access restriction.
Prompted if TKTP = TIE.
(CTD)
CUN
FR1
FR2
FRE
SRE
TLD
UNR
Conditionally Toll Denied
Conditionally Unrestricted
Fully restricted class 1
Fully restricted class 2
Fully restricted
Semi-Restricted
Toll Denied
Unrestricted
CLID Calling Line Identification. CLID is prompted
only for UIPE-based protocols.
OPT0 Prefix = 0 for North American dialing plan.
OPT0 is the default for ESIG and ISIG
interfaces.
OPT1 Prefix = 1 for international PFXs in CLID. Any
numbering type is supported. OPT1 is the
default for all EuroISDN interfaces.
OPT2 Prefix = 2, for international PFXs in CLID.
CCITT numbering types supported are:
UKWN, INTL, NPA, and NXX. OPT2 is the
default for CO/DID routes for the Telecom
New Zealand interface. For an interworking
scenario, when the CLID option is OPT2,
and the CPFXS prompt is NO, then the
calling number is built based on the
originating calling number type.
isa-12
euroisdn-22
412 Nortel Communication Server 1000 April 2011