CS1000 Software Input Output Reference - BT Business

Prompt Response Comment Pack/Rel
• layer 1: physical layer
• layer 2: link layer
• layer 3: network layer
These layers provide a standard interface for
voice and data communication. Each layer
uses the services provided by the layer
below, and builds on these services to
perform functions for the layer above. Each
layer or block can be modified without
affecting the protocols in another layer.
loop x Enter loop number for additional PRI loops
using the same D-channel and the interface
ID for the additional loop numbers. Where:
• loop = 0-159 for PRI loop number
• loop = 0-255, systems with Fibre Network
Fabric
• x = 2-15 for Interface ID or 1-126 if IFC=
D70 or CNTY = JAPN
The PRI prompt is used to assign the PRI
loops controlled by the D-channel. Each loop
is given an Interface ID.
The PRI loop carrying primary D-channel
(DCHI) and backup D-channel (BCHI) are
assigned an Interface ID 0 and 1,
respectively. The 14 remaining PRI loops
that can be assigned to the D-channel are
defined here and given an Interface ID of
2-15.
card x For Small System
Where:
• card = 1-9 for PRI card number
• card = 1-9 11-19 21-29 31-39 41-49 with
Survivable IP
• card = 11-14, 21-24, 31-34, 41-44 for CS
1000S
• x = 2-15 for Interface ID or 1-126 if IFC=
D70 or CNTY = JAPN
Precede with X to remove. This prompt is
repeated until is entered.
Alphabetical list of prompts
fnf-25
sipe-25
basic-1
Nortel Communication Server 1000 April 2011 549