Thermo Miran Sapphire XL Manual 2005 - IE Monitoring Instruments

Chapter 4 Operation
STARTUP PROCEDURE
Press the ON/OFF button to activate the instrument. The first menu to appear is the Main
Menu, shown below.
If the application shown on the Main Menu is the one that is wanted, press “1” or ENTER
to display the Zero Menu, shown on page 4-6.
┌────────────────────────────────────────┐
│╒══CURRENT APPLICATION══╕ MAIN MENU │
││ │ ───── │
││ │1=Analyze/Start│
││ │ ───── │
││ METHANE: ---- ppm │2=Change gas │
││ │3=Site info │
││ │4=Config/Setup │
│└───────────────────────┘5=Report/Data │
└────────────────────────────────────────┘
Main Menu
If an application other than that on the Main Menu is desired, press 2 to display the Select
Applications menu shown below. This menu presents up to five of the most recently
selected applications. If one of the applications shown in this menu is selected, the
display skips to the Zero menu, shown below.
Note: Any application in the Select Applications menu will be removed when a new
application is downloaded from a PC. These applications are not removed from the
instrument, and can be accessed from the user libraries via the Applications menu, shown
below.
┌────────────────────────────────────────┐
│╒══CURRENT APPLICATION══╕Select applic: │
││ │1=BUTANE │
││ │2=ETHANE │
││ │3=FULL-L-SCAN │
││ METHANE: ---- ppm │4=XYLENE-H-13.1│
││ │5=XYLENE-L │
││ │ │
│└───────────────────────┘ Enter=More │
└────────────────────────────────────────┘
Select Applications Menu
The Select Applications menu will be omitted if no previous applications have been
selected, and the Applications menu will be displayed. If none of the applications
appearing in the Select Applications menu are desired, press ENTER to view the
Applications menu, shown on page 4-5.
4-4