English (United Kingdom) - Paul Wurth

Technical specification
Customer: Paul Wurth S.A.
Project:
Location:
Paul Wurth Paint Systems Standard/ FOR 519E / Rev 6 Version:
Position: Paint System Type F/ near slag pit(s)
but not in coastal area
Area: 10 m2 System:
Date: 06.07.2010 Prepared by: Christian Boge Checked by: Issued by Jotun
Pretreatment: All areas to be cleaned thoroughly with strong detergents and high pressure fresh water to remove oil, grease, salt and contaminations. All
areas to be blastcleaned to Sa 2½ (ISO 8501-1:1988).
Filmthickness
(µm)
Recoating intervals
Coat Product
no.
Area to
paint
Vol.
solids
Dry
spec.
Wet
spec.
Loss (%) 23°C 40°C Thinner Consumption incl.
loss
% % Min Max Min Max No. Max% m2/ltr Total ltr.
1 Epoxy HR, aluminium
100 63 120 190 0 10 h 7 d 4 h 3 d
23 0 5,3
2
2 Epoxy HR, light grey
100 63 120 190 0 10 h 7 d 4 h 3 d
23 0 5,3
2
240
* please refer to the relevant technical datasheets for recoating and curing conditions
Remarks:
Unless otherwise agreed in writing, all product supplied and technical advice given by us are subject to our standard terms and conditions of sale. In the event that supplies are made and technical advice is
given by one of our associated companies or dealers, then such supplies and technical advice shall be subject to the standard terms of sale of that company, a copy of which is available upon request. The
given data must be considered as guidelines only, the figures in some colums may be rounded. Drying times and paint consumptions may vary depending on actual conditions.
For updated information about our products please refer to our web site at www.jotun.com
Printed 06.07.2010 17:40:56 Page 5