Geovision NVR Software Installation Guide - Use-IP
Geovision NVR Software Installation Guide - Use-IP
Geovision NVR Software Installation Guide - Use-IP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Assigning Addresses to GV-I/O Box 4<br />
2<br />
Hardware Accessories<br />
Up to 9 pieces of GV-I/O Box 4 can be chained together to expand the I/O capacity. <strong>Use</strong><br />
the ID switch to assign addresses 1~ 9 to the connected pieces of GV-I/O Box 4.<br />
E<br />
RJ-11 to USB Cable or<br />
RJ-11 to DB9 Cable<br />
B<br />
www.geovision.com.tw<br />
DO 1<br />
DO 2<br />
DO 3<br />
DO 4<br />
com.B<br />
DI 1<br />
DI 2<br />
DI 3<br />
DI 4<br />
com.A<br />
RX<br />
TX<br />
DC 12V<br />
GV-IOBOX 4<br />
www.geovision.com.tw<br />
DO 1<br />
DO 2<br />
DO 3<br />
DO 4<br />
com.B<br />
DI 1<br />
DI 2<br />
DI 3<br />
DI 4<br />
com.A<br />
Figure 2-47<br />
RX<br />
TX<br />
DC 12V<br />
GV-IOBOX 4<br />
www.geovision.com.tw<br />
DO 1<br />
DO 2<br />
DO 3<br />
DO 4<br />
com.B<br />
DI 1<br />
DI 2<br />
DI 3<br />
DI 4<br />
com.A<br />
1. Address 0 and A to F are NOT functional.<br />
2. Assign the addresses when the power is off.<br />
3. If you want to change the assigned address of the connected GV-I/O<br />
Box 4, set the switch to the new address, and then re-plug the power<br />
adaptor.<br />
RX<br />
TX<br />
DC 12V<br />
GV-IOBOX 4<br />
105