Template BA B168xH238 - Hörmann

ENGLISH14Displays for Errors/Warnings and Operating ConditionsIf there is an error or warning, a number will appear with a rapidly flashing decimal point.14.1Display of errors and warningsDisplay Error/warning Possible cause RemedyReversal limit cannot be set An obstacle was in the way when Remove the obstructionthe SKS/VL reversal limit was setPartial opening height cannot besetThe partial opening height is tooclose to the CLOSE end-of-travelposition (≤ 120 mm slide travel)The partial opening height must be higherEntry not possibleNot possible to give a travelcommandThe parameter is set to 0 inmenu 4 and an attempt wasmade to activate automatictimed closing (menu 3,parameters 1 – 9)The operator has been blockedfor the control elements and atravel command was givenActivate the safety device(s)Run time limitation The belt is torn Exchange the beltThe operator is defectiveRelease the operator for the control elementsExchange the operatorSystem error Internal error Restore the factory setting (see Section 4.6), teach inthe operator again or exchange, if necessaryForce limitThe door is sluggish or does notmove smoothlyObstruction in door areaCorrect the door travelStatic current circuit The wicket door is open Close the wicket doorThe magnet has been fitted thewrong wayThe testing result is not OKRemove the obstruction and teach in the operatoragain, if necessaryFit the magnet correctly (see the instructions for thewicket door contact)Exchange the wicket door contactPhotocell No photocell is connected Connect a photocell or set the parameter to 0 inmenu 4The light beam is interrupted Adjust the photocellThe photocell is defective Exchange the photocellClosing edge safety device The light beam is interrupted Check the transmitter and receiver and exchange, ifnecessary, or exchange the complete closing edgesafety device8k2 resistance contact strip isdefective or not connectedCheck the 8k2 resistance contact strip or connect tothe operator via the 8k2-1T decoder unitNo reference point Power failure Move the door to the OPEN end-of-travel positionThe operator has not beentaught inThe operator has not beentaught in yetTeach in the operator14.2Display of the operating conditions of the operatorThe operator is in the OPEN end-of-travel positionThe operator is in an intermediate positionThe operator is currently in motionThe operator is in the CLOSE end-of-travel positionThe operator is in the partial opening positionImpulse input from a radio code38 TR10A041-F RE / 06.2010