Sch./Ref./RÃ©f./Typ 1092/601 Mod. 1092

More documents

Recommendations

Info

INSTALLATION INSTRUCTIONS Avoid pointing the lens directly towards the sun or intense sources of light, even when the dome isoff. The subject must not be backlit. Some lighting systems (e.g. coloured fluorescent lights) may distort the colours. Arrange a suitable circuit breaker and fuse upstream of the devices. Make sure that the rating plate data corresponds to the power specifications before connecting thedevice to the mains.SAFETY PRECAUTIONS Avoid introducing any object or liquid into the device. If this should accidentally occur, disconnect thedevice from the mains and have it inspected by qualified personnel.INSTALLATION PRECAUTIONSArrange the device in a well-ventilated place to prevent overheating.For the same reason, do not install sources of heat, such as radiators or hot air ducts. Keep awayfrom direct sunlight. Do not install in areas subject to excessive dust, mechanical vibrations orshocks.Take the operating temperature range of the device (from 0°C to +40°C) into account when choosingthe installation place. Do not install the unit over another unit which generates heat.Wait for a while before operating a device immediately after transporting it from a cold place to awarm place and vice versa. Wait on average for three hours: this will allow the device to adapt to thenew ambient (temperature, humidity, etc.).Do not arrange this device on an unstable surface, such as a tottering or slanted table. The devicecould fall causing injury or mechanical failures.30 DS<strong>1092</strong>-041C
CEILING INSTALLATIONMake sure that no units are powered before starting the installation procedure.Secure the circular bracket to one of the two ends of the threaded union tube. Block the two parts using the two flared screws provide (screw 1).321Insert the connection wire (included) into the central hole of the circular bracket so that it protrudesfrom the union tube.Grasp the protruding end of the wire and plug it into the dome in the terminal board as shown in thefigure.DS<strong>1092</strong>-041C 31
Page 1 and 2: -+DS1092-041CMod.1092MINIDOME P/T/Z
Page 3: CONTENUTO DELLA CONFEZIONE N°1 Min
Page 7 and 8: INSTALLAZIONE A PARETEPrima d’ini
Page 9 and 10: COLLEGAMENTICollegare il cavo in do
Page 11 and 12: Opzione Valore SpiegazioneFOCUS /EX
Page 13 and 14: Per mezzo dei tasti “freccia”
Page 16 and 17: EXPOSURE- ESPOSIZIONEQuesta funzion
Page 18 and 19: SENS-UP (DSS) - VARIAZIONE DELLA SE
Page 20 and 21: IMAGE ADJSelezionando IMAGE ADJ e p
Page 22 and 23: IMPOSTAZIONI DI BAUD RATEE’ possi
Page 24 and 25: IMPOSTAZIONE E ATTIVAZIONE DELLE FU
Page 26 and 27: Impostare la scansione su 360° con
Page 28 and 29: ENGLISHPRECAUTIONSMake sure that th
Page 32 and 33: Fasten the dome to the end of the u
Page 34 and 35: Secure the bracket to the dome usin
Page 36 and 37: USING THE MENUThe THERA 4 mini dome
Page 38 and 39: WHITE BALThis option is used to sel
Page 40 and 41: Option Value ExplanationLENS INITEN
Page 42 and 43: EXPOSUREThis function is used to ad
Page 44 and 45: SENS-UP (DSS) - FOR ADJUSTING CAMER
Page 46 and 47: IMAGE ADJSelect IMAGE ADJ and press
Page 48 and 49: SETTING THE BAUD RATEThe communicat
Page 50 and 51: FUNCTION SETTING AND ACTIVATIONImpo
Page 52 and 53: Setting 360° continuous panThis fu
Page 54 and 55: FRANÇAISPRECAUTIONS D’UTILISATIO
Page 56 and 57: NORMES D’INSTALLATION Eviter de d
Page 58 and 59: Visser le dôme sur l’extrémité
Page 60 and 61: Fixer l’étrier au dôme, en util
Page 62 and 63: CLAVIERBOITE DECONNEXIONInsérer la
Page 64 and 65: Option Valeur ExplicationFOCUS /EXP
Page 66 and 67: A l’aide des touches « flèches
Page 68 and 69: ZOOM/FOCUS POS SETUP:TELE:NEAR:WIDE
Page 70 and 71: En sélectionnant IRIS VAL et en ap
Page 72 and 73: Option Valeur ExplicationUSER PRESE
Page 74 and 75: PROGRAMMATION DU DÔMEPour définir
Page 76 and 77: DESCRIPTION DES FONCTIONS ACCESSIBL
Page 78 and 79: Mémoriser tous les presets à incl
Page 80 and 81:
DIAGNOSTICPROBLEMES CAUSES POSSIBLE
Page 82 and 83:
INHALT DER VERPACKUNG 1 Minidome P/
Page 84 and 85:
DECKENMONTAGEVor der Installation s
Page 86 and 87:
WANDMONTAGEVor der Installation sic
Page 88 and 89:
ANSCHLÜSSEDas Anschlusskabel mit d
Page 90 and 91:
Option Wert ErklärungFOCUS /Auswah
Page 92 and 93:
BACKLIGHT - BLCEin ausgewählter Ge
Page 94 and 95:
Auswahl ONE-PUSH (Der Focus kann ü
Page 96 and 97:
Auswahl IRIS VAL und durch betätig
Page 98 and 99:
Option Wert ErklärungUSER PRESET O
Page 100 and 101:
EINSTELLUNGEN DOMEDie externe und i
Page 102 and 103:
BESCHREIBUNG DER FUNKTION UNTER EIN
Page 104 and 105:
Eingabe einer Track-TourIm Modus St
Page 106 and 107:
REINIGUNG DER VORRICHTUNGEin trocke
Page 108 and 109:
ESPAÑOLPRECAUCIONESAsegúrese de q
Page 110 and 111:
INSTRUCCIONES DE INSTALACIÓN Evite
Page 112 and 113:
Fije el domo al extremo del tubo de
Page 114 and 115:
Fije el soporte al domo mediante lo
Page 116 and 117:
TECLADOCaja deconexiónDOMODOMODOMO
Page 118 and 119:
Opción Valor ExplicaciónFOCUS /Es
Page 120 and 121:
Pulse las teclas de desplazamiento
Page 122 and 123:
ZOOM/FOCUS POS SETUP:TELE:NEAR:WIDE
Page 124 and 125:
Seleccione IRIS VAL y pulse las tec
Page 126 and 127:
Opción Valor ExplicaciónUSER PRES
Page 128 and 129:
CONFIGURACIÓN DEL DOMOPara configu
Page 130 and 131:
DESCRIPCIÓN DE LAS FUNCIONES USAND
Page 132 and 133:
Continúe memorizando las posicione
Page 134 and 135:
SOLUCIÓN DE PROBLEMASPROBLEMAS POS
Page 136:
DS1092-041CProdotto in Cina su spec
show all

Sch./Ref./RÃ©f./Typ 1092/601 Mod. 1092

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?