Sch./Ref./Réf./Typ 1092/601 Mod. 1092

DOME SETTINGSThe external dome and the internal dome must be removed in the following manner to set the address, thebaud rate and the communication protocol:7. Turn the external dome anticlockwise by approximately ¼ a turn to release it from its seat.8. Turn the internal dome anticlockwise by approximately ¼ a turn to release it from its seat.9. After removing the two parts, access the dip switches inside the dome.DIP SWITCH10. Use the small screwdriver (included) for making the necessary settings.11. Position the internal dome on the support making the holding tabs of the dome itself with the holes onthe support and turn it clockwise until it locks.12. Position the external dome on the support and turn it clockwise until it is blocked.SETTING THE ADDRESSThe default address of the THERA 4 dome is 1.To change the address according to the connected devices, use the dip switches on the PCD of the domeas shown in the figure.DEFAULT SETTINGSONON1 23 4 5 6 7 81 2 3 4 5 6 7 812128644 32816DOME ADDRESS CALCULATION EXAMPLEON1 23 4 5 6 7 8(2+4+16=22) The address is 22DS1092-041C 47