Motors-D81.1-complete-English-06-2020

© Siemens 2020
Introduction
Mounting technology
Special technology
1 ■ Overview
HOG 9 DN 1024 I rotary pulse encoder
~67
~117
~Ø97
Ø16
H7
~Ø86
G_M015_XX_00213a
The encoder is fitted with insulated bearings.
The HOG 9 DN 1024 I rotary pulse encoder can be supplied already
mounted.
Order code G05
The HOG 9 DN 1024 I rotary pulse encoder can be retrofitted.
The motor must be prepared for this. When the motor is ordered,
the option "Prepared for mountings, center hole only", order code
G40, or the option "Prepared for mountings with shaft D16", order
code G42, must be specified (see "Mechanical version and degrees
of protection" on page 1/76). The rotary pulse encoder is
not part of the scope of supply in this case.
Manufacturer:
Baumer Hübner GmbH
Max-Dohrn-Str. 2+4
10589 Berlin, Germany
Phone +49 (30) 69003-0
Fax +49 (30) 69003-104
www.baumer.com
Email: sales@baumerhuebner.com
Mounting dimensions of HOG 9 DN 1024 I rotary pulse encoder
Technical specifications for HOG 9 DN 1024 I (HTL version)
Mounting of encoder for temperatures below –20 °C and higher
than +40 °C available on request.
Supply voltage U B
+9 V to +30 V
Current input without load 50 to 100 mA
Admissible load current per output 150 mA, 800 mA peak
Pulses per revolution 1024
Outputs
6 short-circuit-proof square-wave pulses
A+, A-, B+, B-, R+, R-
Pulse offset between the two 90° 20 %
outputs
Output amplitude
U High U B –3.5V
U Low 1.5 V
Mark space ratio 1:1 20 %
Edge steepness
10 V/µs
Maximum frequency
120 kHz
Maximum speed
7000 rpm
Temperature range –30 to +100 °C
Degree of protection
IP56
Maximum adm. radial cantilever 500 N
force
Maximum adm. axial force 400 N
Connection system
M23 flange socket, radial
(mating connector is part of the scope
of supply)
Mech. version acc. to
73 522 B
Baumer Hübner Ident. No.
Weight
approx. 0.9 kg
1/96 Siemens D 81.1 · 06/2020