1 informazioni generali - Beta

REMOVING THE PLASTICS FOR ALP
To facilitate checks and operations in certain
areas of the vehicle, it is essential to
remove the bodywork sections as described
below.
Removing the saddle
•Unloosen the clamping screw A and then
remove the saddle by pushing it towards
the rear of the vehicle so as to disengage
it from the hook on the fuel tank.
Disassembling rear handles
•Unscrew the two clamping screws B then
remove the other clamping screw E, positioned
under the rear mudguard and thus
remove the handles C, taking care not to
mislay the rubber shims.
Disassembling rear tail
•Remove the clamping screw F and remove
the tail D.
Disassembling front sides
•Unscrew the four clamping screws G
(two on each side) and remove the two
screws H.
•Remove the front sides, being careful to
remove the left side first and then the right
side.
133
3
CHECKS AND MAINTENANCE
GB