technical & service manual dc inverter multi-system air conditioner

English
2-4. Outer Dimensions of Outdoor Unit
A
340
376
410
2-5. Diagram of Outdoor Unit Installation
Never install only a single indoor unit.
Over 10cm
Ensure 15cm
of space if a
drain hose is to
be used.
Over 50cm
A
940 80
Be sure to connect indoor and outdoor units only in
combinations that are listed in the catalog or in the
combination table that was provided with the outdoor unit.
(Use caution. Connecting any other model may result in
operation failure and malfunction.)
The dimensions indicated by in the figure below are
spaces that are required in order to maintain
performance. Install in a location where the dimensions
indicated by are ensured, and where 2 or more faces
of the unit are unobstructed. In principle, the top direction
should be unobstructed.
Base (not provided)
(concrete or similar material)
Fasten with anchor bolts
(not provided)
(3/8" or M10, 4 locations)
E
D
C
B
A
10
30
910
75 75 75 75
168
51
110
75 75 75 75
131
Service valve on wide tube side
(Outer diameter 12.70)
Service valve on narrow tube side
(Outer diameter 6.35)
Service valve on wide tube side
(Outer diameter 9.52)
Fig. 6a unit: mm
Over 20cm
Leakage breaker
/fuse link
Fig. 6b
Ground
wire
(not
provided)
Service space
Over 25cm
Terminal cover
Indoor unit E
Indoor unit D
Indoor unit C
Indoor unit B
Indoor unit A
Access panel C