und Installationsanleitung (pdf) - dz-schliesstechnik gmbh

2.5.3 Overall terminal diagram 720-30 with terminal module 1370-10F 10,5 ATF 22 ATF 51,25 AT=F 31,25 ATF 61,25 ATPO 1Setting rangeOutput voltage24 V +10%PO 2Battery charge voltage(See operating instructions)Emergency exit control unit 720-30F 70,1 ATL1 N PEAK 1 AK 2+ - + -1 2 3 4 5 6 7 8 9 10 11 12 13 14 15The control unit andterminal module must beconnected via the cableshields. However, thesemust only be grounded onone side (at the controlunit).The shields of allconductors occurring atthe control unit must beconnected here to thegrounding bar. They mayonly be grounded on oneside.Jumper J1The sabotage contact ofthe terminal module canbe set as a n.c. or n.o.contact using jumper J1.In the control unit 720-30it must be set as a n.o.contact.For this reason, it mustbe plugged over toposition 2-3. Note: Thestatus on delivery isposition 2-1!L1 N PEMains voltage230 V / 50-60 HzABC5 6 4 3 2Battery12 V, 2 AHBattery12 V, 2 AHD E F16 23 17 18 22 19 20 21 14 13 1 2 3 4 5 6SK3 1J12rdgn yeTerminal module 1370-10/11Sabotage contact,(switching position: lid open)Reset alarm / unlockLock / temporary releaseLockedUnlockedAlarm5 6 4 3 27 8 9 10 11 12Locking elementconnection,Note:When two locking elementsare connected to the controlunit (e.g. in the case oftwo-leafed doors), both the doorcontact and the locked statusmonitors (armature contact /Hall element) must be switchedin series.72Holding magnetmodel 828, 24 VDoorcontactDoorcontactHolding magnetmodel 828, 24 V