VTrak E-Class Product Manual - Promise Technology, Inc.

VTrak E-Class Product Manual
Reported Event Corrective Action
Physical disk is no longer
assigned as dedicated
spare
Physical disk has been
inserted
Physical disk has been
removed
Bad sector is found on
physical disk
Error is detected in remap
sectors
Command times out on
physical drive
Physical disk negotiation
speed is decreased.
Previously configured disk
is no longer found
A physical disk has
encountered an unknown
(non-ECC) media error.
A physical disk has
encountered PFA
condition
A configured dead
physical drive has been
inserted
A physical drive page 0/1
settings have been
changed
Physical disk is marked
as dead due to removal/
failure of reassign
sectors/PFA condition/
forced offline state
PSU (Power Supply Units)
Result of settings or user action. Normal.
A disk drive has been inserted into the VTrak
subsystem.
A disk drive has been removed from the VTrak
subsystem.
Disk drive has a bad sector. The drive should remap
around the bad sector. If this message appears
repeatedly, replace the disk drive.
Disk drive has a bad remap sectors. If this message
appears repeatedly, replace the disk drive.
Disk drive not responding to commands. If this
message appears repeatedly, replace the disk drive.
Disk drive had to reduce its data rate. If this message
appears repeatedly, replace the disk drive.
Disk drive may have failed or was removed from the
enclosure. Replace or reinstall the disk drive as
needed.
Disk drive experienced an unknown error. If this
message appears repeatedly, replace the disk drive.
A potentially faulty address or bad sector was found.
The disk drive inserted into the VTrak was marked as
dead and will not work on the VTrak. Replace the disk
drive.
Result of settings or user action. Normal.
Replace the disk drive.
282