VTrak E-Class Product Manual - Promise Technology, Inc.

Connecting the Power
33
Chapter 2: VTrak Installation
Plug the power cords and switch on both power supplies on. When the power is
switched on, the LEDs on the front of the VTrak will light up.
Figure 23.VTrak front panel LED display. The E310f/s display is shown. The
E610f/s display is similar
Power
FRU Status
When boot-up is finished and the VTrak is functioning normally:
• Controller LED blinks green once per second for five seconds, goes dark for
ten seconds, then blinks green once per second for five seconds again.
• Power, FRU and Logical Drive LEDs display green continuously.
• Controller LEDs flash green if there is activity on that controller.
There are two LEDs on each disk drive carrier. They report the presence of
power and a disk drive, and the current condition of the drive.
Figure 24.VTrak disk drive carrier LEDs
Logical Drive Status
Controller-1 Activity
Controller-2 Activity
Controller Heartbeat
Disk Status
Power/Activity
After a few moments the Power/Activity LED should display Green. If there is no
disk drive in the carrier, the Power/Activity LED will remain dark.