22.03.2013 Views

Enabler II-G Assiste GPS Integration Guide - Farnell

Enabler II-G Assiste GPS Integration Guide - Farnell

Enabler II-G Assiste GPS Integration Guide - Farnell

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Enfora <strong>Enabler</strong> <strong>II</strong>I-G<br />

Modem <strong>Integration</strong> <strong>Guide</strong><br />

6.6.25. Headset Speaker Output Left & Right (Pins 57, 59)<br />

Pin Name Pin Number Signal Direction Description<br />

HSOL 57 O Headset Out 32Ω Speaker Left<br />

HSOR 59 O Headset Out 32Ω Speaker Right<br />

HSOVMID 61 I Headset Out pseudo ground return<br />

The left and right headset amplifiers provide the stereo signal on terminals HSOL and HSOR. A pseudo<br />

ground is provided on terminal HSOVMID to eliminate external capacitors. The mono audio signal can be<br />

provided on the Right or the Right and Left headset outputs. HSOVMID is available to allow integrators to<br />

supply a bias or DC offset to increase the dynamic range of the Headset.<br />

Headset Spkr Output Parameter/Conditions Min Typ Max Units<br />

Maximum Swing Distortion ≤ 2% and 32 Ω, VSP<br />

input level = +3 dBm0<br />

1.6 1.96<br />

Distortion ≤ 2% and 32 Ω, I 2 VP-P<br />

S<br />

input level = +3 dBm0<br />

1.48 1.85<br />

Maximum Capacitive<br />

Load<br />

100 pF<br />

Minimum resistive load<br />

at HSOL and HSOR:<br />

Zload<br />

32 Ω<br />

Amplifier Gain -5 dB<br />

HSOL/R amplifier Power<br />

supply rejection<br />

1 kHz, 100 mVpp<br />

50 dB<br />

Amplifier State in Power<br />

Down<br />

High Z<br />

The left and right channels of the headset speaker output are a single ended output. An external audio<br />

amplifier should be used for loads of less than 32 Ω or if volume is inadequate.<br />

6.6.26. Headset Output Common Mode (Pin 61)<br />

The left and right headset amplifiers provide the stereo signal on terminals HSOL and HSOR. A pseudo<br />

ground is provided on terminal HSOVMID to eliminate external capacitors.<br />

HSOVMID Parameter/Conditions Min Typ Max Units<br />

Maximum Capacitor<br />

Load<br />

200 pF<br />

DC Level 1.2 1.35 1.5 V<br />

GSM0308PB001 58 Version 1.03– 7/17/2007

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!