Enabler II-G Assiste GPS Integration Guide - Farnell

Enfora Enabler III-G
Modem Integration Guide
In the following examples, the and are intentionally omitted for clarity and space.
10.1.3. Initial Response to the AT Command
After power is applied to the Enfora Enabler III-G module, the module performs a power-up selftest.
The self-test completes within one (1) second. When queried with the AT command, the
Enfora Enabler III-G module responds with one of the following result codes:
• OK signifies that the Enfora Enabler III-G module is ready, that it correctly interprets the AT
command, and that it has executed the command.
• ERROR signifies that the Enfora Enabler III-G module does not understand the command or
that the command is invalid.
Entry
AT
Response OK Command valid: module is ready
The Enfora Enabler III-G module must be in AT Command mode (please refer to section
10.3 GPRS Packet Examples for packet mode initialization and setup) when any command
is entered (with the exception of the online escape sequence). Commands entered when
the module is in On-line mode are treated as data, and are transmitted as such to the
receiving module. i.e. If the module is in PPP or SLIP mode, AT commands cannot be
entered.
10.1.4. Sending an Initialization String to the Enfora Enabler III-G Module
The following example provides the sample AT commands and responses for the following
initialization tasks:
• Reset the module to the factory defaults
• Disable character echo
• Transmit Result Codes
• Set the module to Verbose mode (to display result codes as words)
• Set the DCD to match the state of remote modem
• Ignore the DTR
Entry AT&FE0Q0V1&C1&d0 Initialization string
Response OK
Command is valid
Entry ATSO=1
Auto answer on 1st ring
Response OK
Command is valid
GSM0308PB001 73 Version 1.03– 7/17/2007