Enabler II-G Assiste GPS Integration Guide - Farnell

More documents

Recommendations

Info

Enfora Enabler III-G Modem Integration Guide • The transmitter and antenna must not be co-located or operating in conjunction with any other antenna or transmitter. Violation of this would allow a user to plug another transmitter in to the product and potentially create an RF exposure condition. 2.2. Disclaimer WARNING The transmitter and antenna must not be collocated or operating in conjunction with any other antenna or transmitter. Failure to observe this warning could produce an RF exposure condition. The information and instructions contained within this publication comply with all FCC, GCF, PTCRB, R&TTE, IMEI and other applicable codes that are in effect at the time of publication. Enfora disclaims all responsibility for any act or omissions, or for breach of law, code or regulation, including local or state codes, performed by a third party. Enfora strongly recommends that all installations, hookups, transmissions, etc., be performed by persons who are experienced in the fields of radio frequency technologies. Enfora acknowledges that the installation, setup and transmission guidelines contained within this publication are guidelines, and that each installation may have variables outside of the guidelines contained herein. Said variables must be taken into consideration when installing or using the product, and Enfora shall not be responsible for installations or transmissions that fall outside of the parameters set forth in this publication. Enfora shall not be liable for consequential or incidental damages, injury to any person or property, anticipated or lost profits, loss of time, or other losses incurred by Customer or any third party in connection with the installation of the Products or Customer's failure to comply with the information and instructions contained herein. The Enabler III-G platform is designed with features to support a robust connection. There are instances where the module performance is beyond the control of the intended design. Integrated designs that require 24 by 7 operation must implement power control via an external circuit or by implementing power management as specified within this design guide. GSM0308PB001 3 Version 1.03– 7/17/2007
Enfora Enabler III-G Modem Integration Guide 3. Manual Overview This document describes the hardware interface of the Enabler III-G modem. The purpose of this document is to define the electrical, mechanical and software interfaces while providing detailed technical information in order to streamline the process of hardware and system integration. 3.1. Revision History Date Rev Author Description 01/17/07 1.00 Tom Cone Initial Release Draft 04/26/07 1.01 Tom Cone Initial Release 07/03/07 1.02 Tom Cone Modified Section 9.4 – Removed Modem Control Library Info Changed reference from GSM0000PB006MAN to GSM0308PB002MAN Replaced host board figures with updated figures Edited references to outdated documents 07/17/07 1.03 Sean Jones Updated Table 2 Serial pin numbers GSM0308PB001 4 Version 1.03– 7/17/2007
Page 1 and 2: GSM0308PB001 Enfora Enabler III-G I
Page 3 and 4: Enfora Enabler III-G Modem Integrat
Page 7: Enfora Enabler III-G Modem Integrat
Page 59 and 60:
Enfora Enabler III-G Modem Integrat
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
show all

Enabler II-G Assiste GPS Integration Guide - Farnell

Create successful ePaper yourself

Delete template?

Save as template?