Enabler II-G Assiste GPS Integration Guide - Farnell
Enabler II-G Assiste GPS Integration Guide - Farnell
Enabler II-G Assiste GPS Integration Guide - Farnell
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Enfora <strong>Enabler</strong> <strong>II</strong>I-G<br />
Modem <strong>Integration</strong> <strong>Guide</strong><br />
2. Configure the COM port as displayed below.<br />
Figure 23 - COM Port Settings<br />
10.1.2. Initialization (AT Command Interface)<br />
In the GSM vocabulary, a call from GSM mobile to the PSTN is called a "mobile-originated call" or<br />
"outgoing call". A call from the fixed network to a GSM mobile is called a "mobile-terminated call"<br />
or "incoming call."<br />
In the following examples, “Entry” refers to the application. The following convention describes<br />
the direction of the data exchange:<br />
• The data exchange from the customer application to the Enfora <strong>Enabler</strong> <strong>II</strong>I-G module is<br />
designated as:<br />
Entry<br />
The data exchange from the Enfora <strong>Enabler</strong> <strong>II</strong>I-G module to the customer application is<br />
designated as:<br />
Response<br />
Note: With the exception of the +++ command (Online Escape Sequence), all commands<br />
must be preceded by the AT attention code (or command prefix) and terminated by<br />
pressing the character.<br />
GSM0308PB001 72 Version 1.03– 7/17/2007
Change language