Logic Pro 9 User Manual - Help Library - Apple

To select all events (of a specified event definition) in the Hyper Editor
Do one of the following:
µ Click the event definition name.
µ Choose Edit > Select All Following of Same Track (or use the Select All Following of Same
Track/Pitch key command, default assignment: Option-Shift-F). All events after the selected
event are selected.
To select all notes of a certain pitch in the Piano Roll Editor
Do one of the following:
µ Click the relevant key on the Piano Roll keyboard.
µ Choose Edit > Select All Following of Same Track (or use the Select All Following of Same
Track/Pitch key command, default assignment: Option-Shift-F).
Important: The selection techniques covered above only affect regions or events that
fall within the cycle area defined in the Bar ruler, when Cycle mode is on.
Switching the Selection Status of Elements
When you make any selection (by dragging or horizontal selection) while holding down
the Shift key, the active selection status of the elements is reversed.
You can also reverse the selection status of all elements by using Edit > Invert Selection
(or use the corresponding key command, default assignment: Shift-I).
For example, if you want to select all regions in a project, with the exception of a few,
you can first select the regions that you do not want to choose, and then use the Invert
Selection command.
Chapter 8 Basic Operations
213