Type III C lass A Program

More documents

Recommendations

Info

E(OOOll) YES was not typed in as the response to the *FORMAT WILL ERASE ••• response. E(00012) DISR NOT ATTACHED The disk specified is not attached to the user. E(00013) FORMAT P R FAILURE Data-loss would result if the command executed. The counts are unchanged. E(00014) FORMAT P R SYS FAILURE The disk is smaller than that required for use of the SYS option. The counts are unchanged, and the user's data is preserved. 382 FORMAT
MAPPRT Purpose: MAPPRT creates, and optionally prints, a file containing a map of entry points in the CMS nucleus. Format: MAPPRT I A I
Page 1 and 2:
Control Program-67/Cambridge Monito
Page 4 and 5:
SNOBOL BRUIN CMS SNOBOL User's Manu
Page 7 and 8:
SPLIT STATE UPDATE INDENT Control J
Page 9:
I/O Format Conversion 336 PLI 338 P
Page 13 and 14:
20 21 22 23 24 25 26 21 28 29 Examp
Page 21:
ampersand (&) arguments. Hitting AT
Page 32 and 33:
The 2741 paper controls (such as th
Page 34:
DATA CHECK. This key should be hit
Page 45 and 46:
anything. followed by a carriage re
Page 54:
Several of the CMS commands create
Page 62:
A brief description of each CMS com
Page 72 and 73:
Examples: a. COMBINE FILE DAOl P3 T
Page 82:
SUMMARY OF EDIT REQUESTS The reques
Page 86:
BOTTOM Request Format: Usage: BOTTO
Page 91 and 92:
FILE Request Format: FILE filename
Page 94:
Examples: a. FIND 90 request: line
Page 97:
c. INSERT request: response: insert
Page 104 and 105:
QUIT Request Format: Usage: QUIT Q
Page 111 and 112:
TABSET Request Format: n1 TABSET TA
Page 114 and 115:
UP Request Format: UP < n > U 1 n i
Page 117 and 118:
ZONE Request Format: I I ZONE Z n1
Page 119 and 120:
ERASE Purpose: The ERASE command de
Page 127 and 128:
Value exceeded the maximum allowabl
Page 130:
LISTF Purpose: LISTF has two purpos
Page 135 and 136:
Usage: Input If filename and filety
Page 139:
the DISK command to be able to read
Page 144 and 145:
When the SCRIPT command is issued,
Page 146 and 147:
E(OOOOO) *** A TERMINAL ERROR HAS O
Page 148:
APPEND Control Purpose: The APPEND
Page 151 and 152:
CENTER Control. Purpose: The line f
Page 153 and 154:
CONCATENATE Control Purpose: CONCAT
Page 155 and 156:
DOUBLE SPACE Control Purpose: -----
Page 160:
INDENT Control Purpose: The INDENT
Page 165 and 166:
NO JUSTIFY Control Purpose: The NO
Page 167 and 168:
PAGE Control Purpose: PAGE causes t
Page 169 and 170:
PAGE NUMBER Control Purpose: The PA
Page 171 and 172:
SPACE Control Purpose: The SPACE co
Page 173 and 174:
TAB SETTING Control Purpose: The TA
Page 175 and 176:
PARAGRAPHS: .br If no space follows
Page 181:
STATE Purpose: The STATE command te
Page 186 and 187:
RET UPDLOG P5 is also created, cont
Page 188 and 189:
CMS commands, and the EXEC command
Page 198 and 199:
line,. or through the number of lin
Page 202:
PROFILE EXEC The PROFILE EXEC featu
Page 209:
SCOOP TXTLIB 1 , OPS TXTLIB i , and
Page 216 and 217:
LOADMOD Purpose: LOADMOD loads into
Page 218:
REUSE Purpose: REUSE reads from dis
Page 238:
load map indicates that program PRI
Page 245:
K. An entry for R is made in the DE
Page 251:
c. GO 12345 The current or1g1n is a
Page 254 and 255:
IPL Format: Usage: IPL The IPL requ
Page 257:
INVALID ARGUMENT The operand specif
Page 263:
----------------- information are s
Page 267:
which the information is stored. Se
Page 277 and 278:
issuing a KO or a CLROVER command.
Page 281 and 282:
LANGUAGE PROCESSORS The language pr
Page 286:
disk. When the assembly is complete
Page 289:
Linkage Notes: SVC X·CA· pc AL4(*
Page 294:
CMSYSREF Macro Purpose: The CMSYSRE
Page 298 and 299:
RDBUF Macro Purpose: RDBUF reads a
Page 300 and 301:
SETUP Macro Purpose: SETUP initiali
Page 302 and 303:
TYPE Macro Purpose: TYPE generates
Page 305:
area following the characters read
Page 309:
DFTRMLST DIRECT DLIST DOM DUMP ENDR
Page 316 and 317:
CPFUNCTN Function Purpose: The CPFU
Page 318 and 319:
FINIS Function Purpose: The FINIS f
Page 322 and 323:
POINT Func.tion Purpose: The POINT
Page 324 and 325:
RDBUF Function Purpose: The RDBUF f
Page 328 and 329:
E(00001) TAPn - SERIOUS TAPE ERROR
Page 333 and 334:
WRBUF Function Purpose: The WRBUF f
Page 335:
FORTRAN Purpose: The FORTRAN comman
Page 339: READY THE PRINTER. I/O ERROR ON PRI
Page 343 and 344: number is shown in Figure 33. The s
Page 347: DIRECT ACCESS I/O All direct-access
Page 354: PL/I PROGRAMMING COMPILATION NOTES:
Page 362: IHECMS--PL/I Initialization Routine
Page 367: SNOBOL ** Purpose: The SNOBOL comma
Page 374: present. When the TRACE option is i
Page 381: CP-61 as a single deck before the c
Page 386 and 387: caused early termination. Examples:
Page 396 and 397: MODMAP Purpose: The MODMAP command
Page 398: OSTAPE assumes the file is going to
Page 407 and 408: c. TAPE LOAD Again using the same t
Page 410: Responses: TAPn NOT READY YET. The
Page 413 and 414: are specifi·ed. xxxxxxxx,RECORDS C
Page 416: CONTROL COMMANDS This section conta
Page 421 and 422: IPL Purpose: IPL causes a new copy
Page 423 and 424: Error Messages: None. KO 413
Page 427 and 428: LINEND takes precedence over the lo
Page 430: Examples: a. LOGIN The user's file
Page 436: SYN Purpose: The SYN command allows
Page 441:
definition is a group of 05/360 ass
Page 450:
BLIP Subroutine Purpose: The BLIP s
Page 457:
Notes: Data Set Block Format Logica
Page 461:
RENAME Subroutine Purpose: The RENA
Page 468 and 469:
PLILIB--PL/I Library The library ne
Page 470:
MACRO LIBRARIES SYSLIB--System Macr
Page 474 and 475:
READY RESET SET SLEEP SPOOL STORE X
Page 476 and 477:
CLOSE Purpose: CLOSE releases the s
Page 478 and 479:
DETACH Purpose: DETACH removes the
Page 480:
DISCONN purpose: DISCONN causes the
Page 486:
Xregl-reg2 PSW Usage: virtual 61 on
Page 489 and 490:
IPL Purpose: IPL causes the Control
Page 491:
IPLSAVE Purpose: Same as IPL except
Page 494 and 495:
44. USER NOT ON SYSTEM userid is no
Page 499 and 500:
Responses: BAD ARGUMENT xx An inval
Page 501 and 502:
READY Purpose: READY simulates a de
Page 503:
SET Purpose: SET allows the user to
Page 507 and 508:
SPOOL Purpose: The SPOOL console fu
Page 509:
Input spooling is then returned to
Page 513 and 514:
e. d xO X o = 00016C80 st xO 123456
Page 520:
TAPE PROCEDURES A facility is avail
Page 526 and 527:
General Recovery Procedures If it i
Page 528:
Set Location counter (SLC) Card The
Page 535:
jobname JOB // userid acctno. // FO
Page 538:
ASSEMBLE Format: I // ASSEMBLE 1 «
Page 546 and 547:
GO Format: I // GO I I < entry poin
Page 549 and 550:
PUNCH Format: I j/ PUNCH I filename
Page 551:
RUNNING THE eMS BATCH MONITOR Setup
Page 555 and 556:
INPUT LINE. All information, up to
Page 557:
TERMINAL SESSION. The period betwee
Page 566 and 567:
TIN x 558 location by information.
Page 568:
PRINT QUIT REPEAT RETYPE SAVE SERIA
Page 572 and 573:
APPENDIX F: CMS FUNCTIONS ATTN CARD
Page 574:
APPENDIX Ql FORMAT OF COMMANDS" REQ
Page 577 and 578:
CMS COMMANDS ALTER ASSEMBLE BLIP BR
Page 579 and 580:
GENMOD GLOBAL IPL KO KT KX LISTF LO
Page 581:
SETOVER SNOBOL SORT SPLIT START STA
Page 584:
5"l'ORE symbol hexloc TIN < CMS > D
Page 588:
LIN}{ userid xxx yyy W < (NOPASS) >
Page 592:
APPENDIX H: CP-61 MACHINE CONFIGURA
Page 604:
Sysref ••••••• 275,28
Page 608:
GH20-0859-0 YOUR COMMENTS PLEASE .
show all

Type III C lass A Program

Create successful ePaper yourself

Delete template?

Save as template?