Type III C lass A Program

More documents

Recommendations

Info

Responses: TAPn NOT READY YET. The specified tape has been attached but it is not ready yet. The following message is received when the tape drive is in a ready status. (OK - READY NOW) The attached tape is now ready for use. Error Messages: E(00001) An invalid function was specified. E(00002) An end of file or end of tape has been reached. E(00003) A permanent I/O error has occurred while reading or writing the tape. E(00004) An invalid symbolic tape unit was specified. ECOOOOS) TAPn NOT ATTACHED. The specified tape is not attached, therefore the function cannot occur. E(OOOOS) Same as prev'ious message i • but the message only prints the first time this error occurs. E(00006) TAPn IS FILE PROTECTED. The specified tape contains no file-protect ring, therefore the tape cannot be erased or written on. E(00001) TAPn - SERIOUS TAPE ERROR ATTEMPTING function An unrecoverable tape error has occurred on the tape while attempting the specified function. 400 TAPEIO
Page 1 and 2:
Control Program-67/Cambridge Monito
Page 4 and 5:
SNOBOL BRUIN CMS SNOBOL User's Manu
Page 7 and 8:
SPLIT STATE UPDATE INDENT Control J
Page 9:
I/O Format Conversion 336 PLI 338 P
Page 13 and 14:
20 21 22 23 24 25 26 21 28 29 Examp
Page 21:
ampersand (&) arguments. Hitting AT
Page 32 and 33:
The 2741 paper controls (such as th
Page 34:
DATA CHECK. This key should be hit
Page 45 and 46:
anything. followed by a carriage re
Page 54:
Several of the CMS commands create
Page 62:
A brief description of each CMS com
Page 72 and 73:
Examples: a. COMBINE FILE DAOl P3 T
Page 82:
SUMMARY OF EDIT REQUESTS The reques
Page 86:
BOTTOM Request Format: Usage: BOTTO
Page 91 and 92:
FILE Request Format: FILE filename
Page 94:
Examples: a. FIND 90 request: line
Page 97:
c. INSERT request: response: insert
Page 104 and 105:
QUIT Request Format: Usage: QUIT Q
Page 111 and 112:
TABSET Request Format: n1 TABSET TA
Page 114 and 115:
UP Request Format: UP < n > U 1 n i
Page 117 and 118:
ZONE Request Format: I I ZONE Z n1
Page 119 and 120:
ERASE Purpose: The ERASE command de
Page 127 and 128:
Value exceeded the maximum allowabl
Page 130:
LISTF Purpose: LISTF has two purpos
Page 135 and 136:
Usage: Input If filename and filety
Page 139:
the DISK command to be able to read
Page 144 and 145:
When the SCRIPT command is issued,
Page 146 and 147:
E(OOOOO) *** A TERMINAL ERROR HAS O
Page 148:
APPEND Control Purpose: The APPEND
Page 151 and 152:
CENTER Control. Purpose: The line f
Page 153 and 154:
CONCATENATE Control Purpose: CONCAT
Page 155 and 156:
DOUBLE SPACE Control Purpose: -----
Page 160:
INDENT Control Purpose: The INDENT
Page 165 and 166:
NO JUSTIFY Control Purpose: The NO
Page 167 and 168:
PAGE Control Purpose: PAGE causes t
Page 169 and 170:
PAGE NUMBER Control Purpose: The PA
Page 171 and 172:
SPACE Control Purpose: The SPACE co
Page 173 and 174:
TAB SETTING Control Purpose: The TA
Page 175 and 176:
PARAGRAPHS: .br If no space follows
Page 181:
STATE Purpose: The STATE command te
Page 186 and 187:
RET UPDLOG P5 is also created, cont
Page 188 and 189:
CMS commands, and the EXEC command
Page 198 and 199:
line,. or through the number of lin
Page 202:
PROFILE EXEC The PROFILE EXEC featu
Page 209:
SCOOP TXTLIB 1 , OPS TXTLIB i , and
Page 216 and 217:
LOADMOD Purpose: LOADMOD loads into
Page 218:
REUSE Purpose: REUSE reads from dis
Page 238:
load map indicates that program PRI
Page 245:
K. An entry for R is made in the DE
Page 251:
c. GO 12345 The current or1g1n is a
Page 254 and 255:
IPL Format: Usage: IPL The IPL requ
Page 257:
INVALID ARGUMENT The operand specif
Page 263:
----------------- information are s
Page 267:
which the information is stored. Se
Page 277 and 278:
issuing a KO or a CLROVER command.
Page 281 and 282:
LANGUAGE PROCESSORS The language pr
Page 286:
disk. When the assembly is complete
Page 289:
Linkage Notes: SVC X·CA· pc AL4(*
Page 294:
CMSYSREF Macro Purpose: The CMSYSRE
Page 298 and 299:
RDBUF Macro Purpose: RDBUF reads a
Page 300 and 301:
SETUP Macro Purpose: SETUP initiali
Page 302 and 303:
TYPE Macro Purpose: TYPE generates
Page 305:
area following the characters read
Page 309:
DFTRMLST DIRECT DLIST DOM DUMP ENDR
Page 316 and 317:
CPFUNCTN Function Purpose: The CPFU
Page 318 and 319:
FINIS Function Purpose: The FINIS f
Page 322 and 323:
POINT Func.tion Purpose: The POINT
Page 324 and 325:
RDBUF Function Purpose: The RDBUF f
Page 328 and 329:
E(00001) TAPn - SERIOUS TAPE ERROR
Page 333 and 334:
WRBUF Function Purpose: The WRBUF f
Page 335:
FORTRAN Purpose: The FORTRAN comman
Page 339:
READY THE PRINTER. I/O ERROR ON PRI
Page 343 and 344:
number is shown in Figure 33. The s
Page 347:
DIRECT ACCESS I/O All direct-access
Page 354:
PL/I PROGRAMMING COMPILATION NOTES:
Page 362: IHECMS--PL/I Initialization Routine
Page 367: SNOBOL ** Purpose: The SNOBOL comma
Page 374: present. When the TRACE option is i
Page 381: CP-61 as a single deck before the c
Page 386 and 387: caused early termination. Examples:
Page 392 and 393: E(OOOll) YES was not typed in as th
Page 396 and 397: MODMAP Purpose: The MODMAP command
Page 398: OSTAPE assumes the file is going to
Page 407 and 408: c. TAPE LOAD Again using the same t
Page 412 and 413: TPCOPY Purpose: The command TPCOPY
Page 414: WRTAPE Purpose: WRTAPE copies fixed
Page 419: . CBARDEF L The line-delete symbol
Page 422 and 423: 1(0 Purpose: The 1(0 command comman
Page 424: KT Purpose: The KT command causes a
Page 428: LOGIN Purpose: LOGIN causes the use
Page 434: with the correct mode. E(00003) GIV
Page 438: . SYN Types a list of the system ab
Page 448: TEXT LIBRARIES This section covers
Page 455: exit was specified in the user's pr
Page 460 and 461:
LOGDSK Subroutine Purpose: The LOGD
Page 465:
with only one argument, the routine
Page 469 and 470:
SSPLIB--FORTRAN Scientific Subrouti
Page 473 and 474:
CONSOLE FUNCTIONS BEGIN CLOSE DETAC
Page 475 and 476:
BEGIN Purpose: BEGIN initiates exec
Page 477 and 478:
spooling areas. Responses: BAD ARGU
Page 479 and 480:
Examples: a. DETACH 181 console fun
Page 484:
PSW = 00000000 80001374 X 2 = 0003A
Page 488 and 489:
EXTERNAL Purpose: EXTERNAL simulate
Page 490 and 491:
UNABLE TO IPL SPECIFIED UNIT TYPE T
Page 493 and 494:
link exists. and a write request is
Page 495:
LOGOUT Purpose: LOGOUT removes the
Page 500 and 501:
e. q temp21 TEMP21 - 032 q temp 4 O
Page 502 and 503:
RESET Purpose: RESET simulates the
Page 506 and 507:
SLEEP Purpose: SLEEP allows the use
Page 508 and 509:
specifying the virtual card reader
Page 512 and 513:
Examples: a. d 12011 L 12010 = 4110
Page 514:
XFER Purpose: XFER controls the pas
Page 523:
search. LOAD, USE, and REUSE normal
Page 527 and 528:
CHANGING OBJECT PROGRAMS Files whic
Page 534 and 535:
CMS BATCH MONITOR The Batch Monitor
Page 537 and 538:
ASSEMBLE // COMMAND // CP // DATASE
Page 544:
output: MAP produces a table of add
Page 547:
E(00004) THE FOLLOWING NAMES ARE UN
Page 550 and 551:
TEXT Format: Usage: // TEXT The car
Page 554 and 555:
CONSOLE FUNCTION. A software facili
Page 556 and 557:
the user has requested information.
Page 559:
READY RESET SET SLEEP SPOOL STORE X
Page 567 and 568:
APPENDIX D: EDIT REQUESTS The EDIT
Page 571 and 572:
.RD n issues the specified number o
Page 573 and 574:
file is opened and given the specif
Page 576 and 577:
typeout userid specified by an opti
Page 578 and 579:
DEBUG DISK DUMP fn ft fro LOAD DUMP
Page 580 and 581:
MACLIB MAPPRT MODMAP OFFLINE OSTAPE
Page 583 and 584:
DEBUG REQUESTS BREAK CAW CSW DEF DU
Page 587 and 588:
CONTROL PROGRAM CONSOLE FUNCTIONS B
Page 591 and 592:
.NC .NF .NJ turns off concatenation
Page 595:
OTHER DEVICES SUPPORTED BY CP-67 Ad
Page 606:
GH20-0859-0 International Business
show all

Type III C lass A Program

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?