Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
c. TAPE LOAD<br />
Again using the same tape, this command erases FILEA from<br />
the disk, and rep1ace it with the tape copy. When the<br />
directory record is processed. the following response is<br />
typed:<br />
FILEA TEXT P1 LOADED.<br />
Note that the mode is now P1. Because there is no tapemark<br />
following FILEA" FILEB is read and replaces the disk copy of<br />
FILEB. The response<br />
FILEB TEXT P1 LOADED.<br />
is followed by the Ready message when the tap ema rk is<br />
encountered.<br />
Another TAPE LOAD command would now copy SYSLIB MACLIB onto<br />
the permanent disk as SYSLIB MACLIB P1. SYSLIB MACLIB SY on<br />
the system disk would not be erased.<br />
Error Messages:<br />
E(00001) INVALID TAPE COMMAND FUNCTION OR PARAMETER LIST.<br />
The format of the command was incorrect, or the operation<br />
specified was unknown. Retry the command. No operation was<br />
performed.<br />
E(00001) FILE NOT FOUND.<br />
The file specified with TAPE DUMP<br />
operation was performed. Check the<br />
retry the command.<br />
was not found.<br />
file designation<br />
No<br />
and<br />
E(00002) FATAL TAPE ERROR WHILE WRITING.<br />
An I/O error occurred which could not be corrected by ten<br />
retries. Notify the operator to replace the tape. This<br />
message is also issued for errors during tape control<br />
operations (REWIND, WRITEOF, SRIP). If TAPE SKIP was issued<br />
at a point beyond which no tapemarks existed, the tape went<br />
to end of reel. A subsequent DUMP, SKIP, or WRITEOF results<br />
in this message.<br />
E(00002) TAPn IS FILE PROTECTED<br />
FATAL TAPE ERROR WHILE WRITING.<br />
The ring is not in the tape, therefore writing cannot occur.<br />
E(00002) TAPn NOT ATTACHED<br />
FATAL TAPE ERROR WHILE WRITING.<br />
The tape is not attached, therefore it cannot be used.<br />
Refer to ·Operating Considerations--Tape<br />
information on tapes.<br />
Procedures" for<br />
E(00002) DISK ERROR WHILE READING.<br />
An I/O error occurred while the file was being transferred<br />
to or from the disk utility file. Retry the command. If<br />
the error recurs. notify the operator. If the file was<br />
delete-after-reading;. see note 2 under COMBINE.<br />
E(00003) FATAL DISK ERROR.<br />
An I/O error occurred, or, for a DISK LOAD, the disk may be<br />
TAPE 391
Change language