ICR 803 Bar Code Scanner BAR CODE MANUAL

More documents

Recommendations

Info

Adding an OCR Check Character You may want to print and verify a check character in order to enhance the security of your OCR application. The OEM Engine can be programmed for almost any type of check character. A number of presets are provided for common check character uses (e.g., modulo 10 and modulo 36). Scan the OCR Modulo 10 or OCR Modulo 36 Check Character bar code to specify the type of check character used in the OCR strings you’re scanning. The imager will then only read OCR character strings with a valid check character. The OEM Engine transmits the OCR data without the check character data. You must specify the location of the check character in the template with a c. Example F: You need to read any combination of 7 digits, with a modulo 10 check character in the 8th position. The template would be: dddddddc To create this template, you would scan the Modulo 10 Check Character symbol. Then scan the Enter OCR Template symbol, scan the d from Appendix D 7 times, and scan the c once. Scan Save OCR Template. This template will let you read any combination of 6 digits with a correct check character after. (If the check character is invalid, the imager will issue an error beep.) For example, the following string could be scanned: and the output would be: 0123456 OCR Modulo 10 Check Character 01234569 Scan this symbol to program the OCR template for a simple modulo 10 checksum of the digits 0 through 9. - 84 -
OCR Modulo 36 Character Set Scan this symbol to program the OCR template for a simple modulo 36 checksum of the digits 0 through 9 and the letters A through Z. OCR Template <strong>Code</strong>s OCR Modulo 36 Check Character Note: Reading more than three rows of OCR is not recommended. Contact the factory if you have an application that requires reading 4 or more rows of OCR. † One or more two-digit numbers and Save are required after reading this programming symbol. Refer to the Programming Chart in Appendix D of this manual. Exit Selections - 85 -
Page 1 and 2:
ICR 803 Bar Code Scanner BAR CODE M
Page 3 and 4:
USB COM Port Emulation Scan the fol
Page 5 and 6:
ICR803 Bar Code Manual - Rev A - 04
Page 7 and 8:
Good Read Indicators ICR803 Bar Cod
Page 9 and 10:
Reread Delay This sets the minimum
Page 11 and 12:
Manual Trigger, Low Power The image
Page 13 and 14:
LED Power Level This selection allo
Page 15 and 16:
Centering Use Centering to narrow t
Page 17 and 18:
Decode Search Mode There are three
Page 19 and 20:
Output Sequence Example In this exa
Page 21 and 22:
Multiple Symbols No Read Note: This
Page 23 and 24:
- 23 -
Page 25 and 26:
To add a backslash (\), scan 5, C,
Page 27 and 28:
Intercharacter, Interfunction, and
Page 29 and 30:
Data Formatting Data Format Editor
Page 31 and 32:
count of the number of suppressed c
Page 33 and 34: Symbologies This programming sectio
Page 35 and 36: - 35 -
Page 37 and 38: Codabar Message Length Scan the bar
Page 39 and 40: Code 39 Message Length Scan the bar
Page 41 and 42: FULL ASCII Full ASCII Code 39 decod
Page 43 and 44: Interleaved 2 of 5 Message Length S
Page 45 and 46: Code 2 of 5 Code 2 of 5 Message Len
Page 47 and 48: Matrix 2 of 5 Matrix 2 of 5 Message
Page 49 and 50: Code 128 ISBT 128 Concatenation In
Page 51 and 52: Telepen Telepen Output Using AIM Te
Page 53 and 54: UPC-A Addenda This selection adds 2
Page 55 and 56: UPC-E0 Addenda Required When Addend
Page 57 and 58: - 57 -
Page 59 and 60: - 59 -
Page 61 and 62: - 61 -
Page 63 and 64: - 63 -
Page 65 and 66: Code 49 Message Length Scan the bar
Page 67 and 68: MicroPDF417 - 67 -
Page 69 and 70: EAN•UCC Emulation The imager can
Page 71 and 72: - 71 -
Page 73 and 74: Korea Post Korea Post Message Lengt
Page 75 and 76: Data Matrix Data Matrix Message Len
Page 77 and 78: Aztec Code Aztec Code Message Lengt
Page 79 and 80: OCR Default All OCR Settings turns
Page 81 and 82: Creating OCR Templates You can crea
Page 83: 9902XZ50 You can string together as
Page 87 and 88: Test Menu When you scan the Test Me
Page 89 and 90: Plessey Code ]P0 n (0x6E) PosiCode
Page 91 and 92: APPENDIX C - Sample Symbols - 91 -
Page 93 and 94: APPENDIX D - Programming Charts - 9
Page 95 and 96: APPENDIX D - Programming Charts - 9
show all

ICR 803 Bar Code Scanner BAR CODE MANUAL

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?