CCNP TSHOOT 6.0 - The Cisco Learning Network

CCNPv6 TSHOOT
Device Configuration File Table
Device Name File to Load Notes
ALS1 Lab71-ALS1-TT-A-Cfg.txt
DLS1 Lab71-DLS1-TT-A-Cfg.txt
DLS2 Lab71-DLS2-TT-A-Cfg.txt
R1 Lab71-R1-TT-A-Cfg.txt
R2 Lab71-R2-TT-A-Cfg.txt
R3 Lab71-R3-TT-A-Cfg.txt
SRV1 N/A Static IP: 10.1.50.1/24
Default gateway: 10.1.50.254
PC-B N/A Static IP: 10.1.80.254/24
Default gateway: 10.1.80.1
PC-C N/A DHCP
Step 3: Configure PC-B.
Configure PC-B with static IP address 10.1.80.254/24 and default gateway 10.1.80.1.
Step 4: Test R3 performance without the TTCP load generator.
Use Cisco IOS commands and pings to record the router performance figures simulating a condition where no
large file transfers are currently being transmitted from PC-B to SRV1. These results can be compared to the
baseline output (selected baseline information is shown) and the output obtained when using the TTCP utility.
Note: Sample output is provided. Depending on your timing and the devices in use, the output and results
may vary.
a. Ping from PC-B to SRV1 (10.1.50.1) and record the results here. Include minimum, maximum, and
average round-trip times.
________________________________________________________________________________
________________________________________________________________________________
C:\>ping 10.1.50.1
Pinging 10.1.50.1 with 32 bytes of data:
Reply from 10.1.50.1: bytes=32 time=3ms TTL=64
Reply from 10.1.50.1: bytes=32 time=1ms TTL=64
Reply from 10.1.50.1: bytes=32 time=1ms TTL=64
Reply from 10.1.50.1: bytes=32 time=1ms TTL=64
Ping statistics for 10.1.50.1:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 1ms, Maximum = 3ms, Average = 1ms
All contents are Copyright © 1992–2010 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 4 of 32