CCNP TSHOOT 6.0 - The Cisco Learning Network
CCNP TSHOOT 6.0 - The Cisco Learning Network
CCNP TSHOOT 6.0 - The Cisco Learning Network
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>CCNP</strong>v6 <strong>TSHOOT</strong><br />
Display Interface Load, Statistics, and Forwarding Information<br />
<strong>Cisco</strong> Express Forwarding is not enabled, the output states<br />
this.<br />
R3#show interfaces fastethernet 0/0<br />
FastEthernet0/0 is up, line protocol is up<br />
Hardware is Gt96k FE, address is 001b.530d.6028 (bia 001b.530d.6028)<br />
Internet address is 10.1.80.1/24<br />
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,<br />
reliability 255/255, txload 1/255, rxload 2/255<br />
Encapsulation ARPA, loopback not set<br />
Keepalive set (10 sec)<br />
Full-duplex, 100Mb/s, 100BaseTX/FX<br />
ARP type: ARPA, ARP Timeout 04:00:00<br />
Last input 00:00:00, output 00:00:00, output hang never<br />
Last clearing of "show interface" counters never<br />
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0<br />
Queueing strategy: fifo<br />
Output queue: 0/40 (size/max)<br />
5 minute input rate 913000 bits/sec, 179 packets/sec<br />
5 minute output rate 62000 bits/sec, 175 packets/sec<br />
381659 packets input, 222009886 bytes<br />
Received 257 broadcasts, 0 runts, 0 giants, 0 throttles<br />
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored<br />
0 watchdog<br />
0 input packets with dribble condition detected<br />
377267 packets output, 20429223 bytes, 0 underruns<br />
0 output errors, 0 collisions, 3 interface resets<br />
0 unknown protocol drops<br />
0 babbles, 0 late collision, 0 deferred<br />
0 lost carrier, 0 no carrier<br />
0 output buffer failures, 0 output buffers swapped out<br />
<strong>The</strong> output of the show interfaces fastethernet 0/0 command above shows the IP address and mask,<br />
hardware (MAC) address, as well as the reliability, transmit (txload), receive (rxload), and details on packet input<br />
and output rates. <strong>The</strong> summary option shown below provides a quick view of input and output queues and bit per<br />
packet transmit and receive rates. As can be seen, there are no packets in the input and output queues.<br />
R3#show interfaces fa0/0 summary<br />
*: interface is up<br />
IHQ: pkts in input hold queue IQD: pkts dropped from input queue<br />
OHQ: pkts in output hold queue OQD: pkts dropped from output queue<br />
RXBS: rx rate (bits/sec) RXPS: rx rate (pkts/sec)<br />
TXBS: tx rate (bits/sec) TXPS: tx rate (pkts/sec)<br />
TRTL: throttle count<br />
Interface IHQ IQD OHQ OQD RXBS RXPS TXBS TXPS TRTL<br />
------------------------------------------------------------------------<br />
* FastEthernet0/0 0 0 0 0 969000 204 94000 201 0<br />
R3#show interfaces fa0/0 stats<br />
FastEthernet0/0<br />
All contents are Copyright © 1992–2010 <strong>Cisco</strong> Systems, Inc. All rights reserved. This document is <strong>Cisco</strong> Public Information. Page 24 of 32
Change language