CCNP TSHOOT 6.0 - The Cisco Learning Network
CCNP TSHOOT 6.0 - The Cisco Learning Network
CCNP TSHOOT 6.0 - The Cisco Learning Network
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>CCNP</strong>v6 <strong>TSHOOT</strong><br />
Task 4: Trouble Ticket Lab 10-1 TT-D<br />
Step 1: Review trouble ticket Lab 10-1 TT-D.<br />
<strong>The</strong> user of PC-C on the branch office network called the help desk again and reported that she is unable to<br />
access SRV1 or the Internet and she is pretty upset. You must restore access to these resources for this<br />
user.<br />
Step 2: Load the device trouble ticket configuration files for TT-D.<br />
Using the procedure described in Lab 3-1, verify that the lab configuration files are present in flash. Load the<br />
proper configuration files as indicated in the Device Configuration File table.<br />
Note: <strong>The</strong> following device access methods are in effect after loading the configuration files:<br />
• Console access requires no username or password.<br />
• Telnet and SSH require username admin and password adminpa55.<br />
• <strong>The</strong> enable password is ciscoenpa55.<br />
Step 3: Restart router R3 after the TT-D file is loaded.<br />
After loading the TT-D file into the running config for router R3 and then copying it to the startup config, use<br />
the reload command to restart the router.<br />
Device Configuration File Table<br />
Device Name File to Load Notes<br />
ALS1 Lab101-ALS1-TT-D-Cfg.txt<br />
DLS1 Lab101-DLS1-TT-D-Cfg.txt<br />
DLS2 Lab101-DLS2-TT-D-Cfg.txt<br />
R1 Lab101-R1-TT-D-Cfg.txt<br />
R2 Lab101-R2-TT-D-Cfg.txt<br />
R3 Lab101-R3-TT-D-Cfg.txt<br />
SRV1 N/A Static IP: 10.1.50.1<br />
Default gateway: 10.1.50.254<br />
PC-B N/A DHCP<br />
PC-C N/A DHCP<br />
Step 4: Configure SRV1 and start the syslog and TFTP servers.<br />
a. Configure SRV1 with the static IP address 10.1.50.1/24 and default gateway 10.1.50.254.<br />
b. Start the syslog server on SRV1 to monitor console messages from multiple devices.<br />
c. Start the TFTP server on SRV1 to record device configuration changes.<br />
Step 5: Release and renew the DHCP lease on PC-B and PC-C.<br />
a. Ensure that PC-B is configured as a DHCP client in the OFFICE VLAN.<br />
b. Ensure that PC-C is configured as a DHCP client in the R3 branch office LAN.<br />
c. After loading all TT-D device configuration files, issue the ipconfig /release and ipconfig<br />
/renew commands on PC-B and PC-C.<br />
All contents are Copyright © 1992–2010 <strong>Cisco</strong> Systems, Inc. All rights reserved. This document is <strong>Cisco</strong> Public Information. Page 12 of 17
Change language