CCNP TSHOOT 6.0 - The Cisco Learning Network

CCNPv6 TSHOOT
debug aaa accounting
show ip ssh
show ssh
sh access-lists
show ip interface fa0/0
Sample Troubleshooting Output
VTY Line-related Commands
Displays the method list defined and being used for AAA
accounting.
Displays SSH status (enabled or disabled), version
number, timeout, retries, and key size in use (for
example: 1024 bits).
Displays active SSH connections with username,
version, mode, encryption, HMAC, and state of the
connection.
Displays currently configured ACLs with type (for
example: standard, extended) and name if one is
assigned. ACL statements are listed with the number of
matches for each one.
Displays IP-related interface information, including any
inbound or outbound access lists configured.
The following commands and outputs are samples from the devices in this lab.
DLS1#show line vty 0
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
1 VTY - - - - - 4 0 0/0 -
Line 1, Location: "", Type: ""
Length: 24 lines, Width: 80 columns
Baud rate (TX/RX) is 9600/9600
Status: Ready, No Exit Banner
Capabilities: none
Modem state: Ready
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
01:00:00 never none not set
Idle Session Disconnect Warning
never
Login-sequence User Response
00:00:30
Autoselect Initial Wait
not set
Modem type is unknown.
Session limit is not set.
Time since activation: never
Editing is enabled.
History is enabled, history size is 20.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed input transports are ssh.
Allowed output transports are telnet ssh.
Preferred transport is telnet.
No output characters are padded
No special data dispatching characters
All contents are Copyright © 1992–2010 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 10 of 22