Trouble Godes - diagramas.diagram...

Model: IS200 2,O IS300 3,O GS300 3,O
Year: 1997-04
Engine code: 1G-FE, 2JZ-GE
System: SF1
General information
Refer to the front of this manual for general test conditions,
terminology, detailed descriptions of wiring faults and a
general trouble shooter for electrical and mechanical faults.
-06100: Trouble codes can be displayed by the MIL or by
using diagnostic equipment connected to the data link
connector (DLC).
-06100: More detailed fault diagnosis information can be
obtained using diagnostic equipment connected to the data
link connector (DLC).
07100-: Trouble codes can only be displayed by using
diagnostic equipment connected to the data link connector
(DLC).
Accessing - flash type +06100
Switch ignition ON.
Bridge data link connector (DLC) terminals 4 and 13 0.
If no trouble codes are stored, the lamp wiii flash twice per
second a.
Each trouble code consists of two groups of one or more
flashes rn [A].
Warning lamp flash duration: 0,5 second [B].
A 0,5 second pause separates each flash rn [C].
A 1,5 second pause separates each trouble code group rn [Dl.
A 2,5 second pause separates each trouble code rn [El.
For example: Two 0,5 second flashes - 1,5 second
pause - one 0,5 second flash. Trouble code 21 displayed
rn - heated oxygen sensor (H02S).
Trouble codes are repeated 4,5 seconds after last trouble
code.
Count MIL flashes. Note trouble codes. Compare with
trouble code table.
Remove bridge wire.
Switch ignition OFF.
Rectify faults as necessary.
[Autodata
LEXUS
Engine management I
The engine control module (ECM) fault memory can also be
accessed using diagnostic equipment connected to the data
link connector (DLC).
More detailed fault diagnosis information can be obtained
using diagnostic equipment connected to the data link
connector (DLC).
ON --------
OFF '
i ;
AD79095
Eng~ne management