05.08.2013 Views

Trouble Godes - diagramas.diagram...

Trouble Godes - diagramas.diagram...

Trouble Godes - diagramas.diagram...

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Engine code: CDPOE, CDPOT, TD27Ti<br />

In fascia fusebox<br />

General information<br />

Bosch EDC<br />

0 Refer to the front of this manual for general test conditions,<br />

terminology, detailed descriptions of wiring faults and a<br />

general trouble shooter for electrical and mechanical faults.<br />

0 <strong>Trouble</strong> codes are displayed by the malfunction indicator<br />

lamp (MIL).<br />

n The ECM fault memory can also be checked using<br />

diagnostic equipment connected to the data link connector<br />

(DLC).<br />

0 Switch ignition ON.<br />

0 Check that MIL illuminates.<br />

0 Start engine. Allow to idle.<br />

0 If MIL extinguishes: No trouble codes have been recorded.<br />

0 If MIL remains illuminated: Access trouble codes.<br />

Accessing<br />

NOTE: Some models will also display trouble codes by the red<br />

LED in the ECM m.<br />

Switch ignition ON.<br />

Bridge data link connector (DLC) terminals IGN and<br />

CHK m.<br />

Wait 2 seconds.<br />

Disconnect bridge wire from data link connector (DLC) m.<br />

Count MIL flashes. Compare with trouble code table.<br />

Long flashes indicate the 'tens' of the trouble code rn [A].<br />

Short flashes indicate the 'units' of the trouble code [C].<br />

A short pause separates each flash rn [B].<br />

A long pause separates each trouble code rn [Dl.<br />

For example: <strong>Trouble</strong> code 12 displayed O.<br />

Switch ignition OFF. Rectify faults as necessary.<br />

/Autodata rrl Eng~ne<br />

Engine management<br />

CHK I IGN<br />

4<br />

management 481

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!