Untitled

More documents

Recommendations

Info

7 Code 2 of 5: The 3060/3080 can decode almost all Code 2 of 5 symbologies automatically. However, to decrease the error rate, we recommend you select only one kind of Code 2 of 5 for reading, or set limited maximum and minimum lengths. The Code 2 of 5 encoding algorithm is weak, so setting the scanner to decode all Code 2 of 5 automatically, or to read variable length Code 2 of 5 bar codes will increase the reading error rate. Check Digit Verification: When this feature is enabled, the 3060/3080 will not read a Code 2 of 5 code printed without the check digit. Check Digit Transmission: When this feature is enabled, the 3060/3080 will transmit the bar code check digit at the end of the scanned data.
Enter Programming Code 2 of 5 Select any Code 2 of 5 ✱ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 Select Standard/Industrial 2 of 5 only . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Select Matrix 2 of 5 only . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Select Interleaved 2 of 5 only . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Select Interleaved 2 of 5 “S” Code only . . . . . . . . . . . . . . . . . . . . . . . . . 4 Select IATA only . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Select Chinese Postal Code only . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Disable check digit verification ✱ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Enable check digit verification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Disable check digit transmission . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Enable check digit transmission ✱ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A Exit Programming 7
Page 2 and 3:
Disclaimer Welch Allyn ® reserves
Page 4 and 5:
The CE mark on the product indicate
Page 6 and 7:
Section 3 Tailoring the Interface (
Page 8 and 9:
Section 5 Building the Message Stri
Page 10 and 11:
Section 7 Symbologies (continued) S
Page 13 and 14:
VALUETEAM 3060 or 3080 Hand held CC
Page 15 and 16:
Reading Width VT3060 60mm 2.3” VT
Page 17 and 18:
Disconnect power to your terminal/c
Page 19:
To program each option, you must: 1
Page 22 and 23:
2 To program the scanner for your t
Page 25:
Once you have programmed your Termi
Page 28 and 29:
3 Output Style: Regular is used
Page 30 and 31:
3 Keyboard Layout: This selecti
Page 33 and 34:
Word Length/Parity . . . . . . . .
Page 35 and 36:
Enter Programming Word Length/
Page 37 and 38:
Enter Programming Baud Rate Ha
Page 39 and 40:
Enter Programming Time Out Con
Page 41 and 42:
Initial signal state Margin time Ex
Page 43 and 44:
Enter Programming Output Pola
Page 45:
Enter Programming Module Time
Page 49 and 50:
Beeper Tone . . . . . . . . . . . .
Page 51 and 52: Enter Programming Beeper Ton
Page 53 and 54: Enter Programming Trigger Mo
Page 55 and 56: Enter Programming Low Power
Page 57: Enter Programming Reread Del
Page 60 and 61: 5 The following diagram illu
Page 62 and 63: 5 Prefix: Prefix Prefix Code ID
Page 64 and 65: 5 Example: Add a prefix or suff
Page 66 and 67: 5 Some terminals drop informati
Page 68 and 69: 5 The following diagram illus
Page 70 and 71: 5 STX/ETX: STX Prefix Code ID S
Page 72 and 73: 5 Prefix and Suffix Code ID: P
Page 74 and 75: 5 Prefix/Suffix Code ID Bar Co
Page 77: The Data Editor selections are used
Page 80 and 81: 6 The Data Editor is used to ed
Page 82 and 83: 6 The Data Editor Control chec
Page 85 and 86: This chapter lists the symbologies
Page 87 and 88: Enter Programming Enable Symbo
Page 89 and 90: Enter Programming Code 39 S
Page 91: Enter Programming Code 39 M
Page 94 and 95: 7 Check Digit Verification: When
Page 96 and 97: 7 Codabar Minimum and Maximum Le
Page 98 and 99: 7 UPC Addenda: This feature is u
Page 100 and 101: 7 EAN Addenda: This feature is u
Page 104 and 105: 7 Code 2 of 5 Minimum and Max
Page 106 and 107: 7 IATA Setting: The IATA is a Co
Page 108 and 109: 7 Code 11: Generally, the Code
Page 110 and 111: 7 Code 93: Code 93 was designed
Page 112 and 113: 7 MSI/Plessey: One or two check
Page 114 and 115: 7 UK/Plessey: The UK/Plessey bar
Page 116 and 117: 7 UCC/EAN-128: The UCC/EAN-128 c
Page 119 and 120: Welch Allyn provides service for it
Page 121 and 122: For service in Japan, please contac
Page 123: Environmental Specifications Operat
Page 126 and 127: A No. Description Beeping Buzzer
Page 128: A If you wish to return the
Page 132: 3060/80/UG Rev C Data Collection Di
show all

Untitled

Create successful ePaper yourself

Delete template?

Save as template?