Untitled

7
Code 11: Generally, the Code 11 format uses 2 check digits for added protection. You must specify the number of check digits the
scanner should recognize. The 3060/3080 calculates the check digits to confirm their validity, but transmission of the check digits to
the host computer is dependent on the check digit transmission selection you make.
Code 11 Minimum and Maximum Length: This selection is used to set the valid reading length of the bar code. If the data length of
the scanned bar code doesn’t match the valid reading length, the 3060/3080 will issue a long error beep. You may wish to set the
same value for minimum and maximum length to force the scanner to read fixed length bar code data. This helps reduce the
chances of a misread.