Optical Telecommunications, Inc.

Version: 2Q05 Standard ICA - New
07/06/05
Attachment 2
Page 10
2.1.4.11.6.1 If OTI fails to submit the spreadsheet(s) specified in Section 2.1.4.11.6 above for
all of its Subsequent Embedded Base within forty (40) days after the date of
BellSouth’s CNL identifying the Subsequent Wire Center List, BellSouth will
identify OTI's remaining Subsequent Embedded Base, if any, and will transition
such circuits to the equivalent tariffed BellSouth service(s). Those circuits
identified and transitioned by BellSouth shall be subject to the applicable
disconnect charges as set forth in this Agreement and the full nonrecurring charges
for installation of the equivalent tariffed BellSouth service as set forth in
BellSouth's tariffs.
2.1.4.11.6.2 For Subsequent Embedded Base circuits converted pursuant to Section 2.1.4.11.6
above or transitioned pursuant to Section 2.1.4.11.6.1 above, the applicable
recurring tariff charges shall apply as of the earlier of the date each circuit is
converted or transitioned, as applicable, or the first day after the end of the
Subsequent Transition Period.
2.1.5 Where facilities are available, BellSouth will install Loops in compliance with
BellSouth’s Products and Services Interval Guide available at BellSouth’s
Interconnection Web site. For orders of fifteen (15) or more Loops, the
installation and any applicable Order Coordination (OC) as described below will be
handled on a project basis, and the intervals will be set by the BellSouth project
manager for that order. When Loops require a Service Inquiry (SI) prior to
issuing the order to determine if facilities are available, the interval for the SI
process is separate from the installation interval.
2.1.6 The Loop shall be provided to OTI in accordance with BellSouth’s TR73600
Unbundled Local Loop Technical Specification and applicable industry standard
technical references.
2.1.7 BellSouth will only provision, maintain and repair the Loops to the standards that
are consistent with the type of Loop ordered.
2.1.7.1 When a BellSouth technician is required to be dispatched to provision the Loop,
BellSouth will tag the Loop with the Circuit ID number and the name of the
ordering CLEC. When a dispatch is not required to provision the Loop, BellSouth
will tag the Loop on the next required visit to the End User’s location. If OTI
wants to ensure the Loop is tagged during the provisioning process for Loops that
may not require a dispatch (e.g., UVL-SL1, UVL-SL2, and UCL-ND), OTI may
order Loop Tagging. Rates for Loop Tagging are as set forth in Exhibit A.
2.1.7.2 For voice grade Loop orders (or orders for Loops intended to provide voice grade
services), OTI shall have dial-tone available for that Loop forty-eight (48) hours
prior to the Loop order completion due date.
2.1.8 OC and Order Coordination-Time Specific (OC-TS)
CCCS 53 of 261