User Guide - Kaspersky Lab

Protection against network attacks 151
4. If you selected a remote address as a network connection property, leftclick
specify the address and enter the IP address, a range of addresses
or subnetwork address for the rule in the window that opens. You can
use one type of IP address or several types for one rule. Several
addresses of each type can be specified.
5. Set the protocol that the network connection uses. TCP is the default
protocol for the connection. If you are creating a rule for applications,
you can select one of two protocols, TCP or UDP. To do so, left-click on
the link with the protocol name until it reaches the value that you need. If
you are creating a rule for packet filtering and want to change the default
protocol, click on its name and select the protocol you need in the
window that opens. If you select ICMP, you may need to further indicate
the type.
6. If you selected network connection settings (address, port, time range),
you will have to assign them exact values as well.
Figure 52. Advanced new rule settings