mediaMAX EVO mediaMAX EVO S2 - FTE Maximal

More documents

Recommendations

Info

ENGLISH 30 User’s Manual - mediaMAX EVO - mediaMAX EVO S2 10.1.2 Use spectrum mode to spot a signal To represent the frequency spectrum on the screen and spot a signal, press the “spectrum” key. When this selection is active, the green led over the key will be switched on. In case of “tv” and “meter” keys are also switched on, the monitor shows a simultaneous representation of spectrum, picture and signal measurements. If these options are not necessary at the moment, it’s possible to switch them off pressing the corresponding keys. To identify a signal, to do it with a span of 50 MHz is advised (default value in terrestrial). For select it, use left and right arrows keys. The span current value is shown at the left bottom part of the monitor. With the spectrum on screen, move the rotary wheel to sweep the frequency band to spot the target signal. In order to semplify the navigation through the terrestrial band, press the “nav” key for select channel mode or frequency mode. • • Channel mode allows to sweep the frequency band by channel defi ned in the standard Frequency mode allows to sweep the band normally by frequency with 50 KHz steps Reserved of technical modifi cations and/or errors rev 2.2
ev 2.2 User’s Manual - mediaMAX EVO - mediaMAX EVO S2 10.1.3 Measurement selection With the target signal identifi ed, it’s necessary to select the signal type (analog or digital). Press “options” key, select “Carrier mode” and there will be two differents options: 1. 2. Analog: if analog signal Digital: if digital signal Select one of them and confi rm clicking the wheel. For digital terrestrial television signal, it is necessary setup signal parameters. Select “Digital modulation”. The adviced confi guration is setup the following options in automatic mode. 1. Mode: auto 2. Spectrum inversion: auto 3. Guard interval: auto 4. Bandwidth: auto 5. Priority: high 6. Offset: auto Press “back” key to turn back the main menu. Reserved of technical modifi cations and/or errors 31 ENGLISH
Page 1: mediaMAX EVO mediaMAX EVO S2 User
Page 4 and 5: ENGLISH 4 User’s Manual - mediaMA
Page 6 and 7: ENGLISH 1 INTRODUCTION 6 User’s M
Page 8 and 9: ENGLISH 8 User’s Manual - mediaMA
Page 10 and 11: ENGLISH 10 User’s Manual - mediaM
Page 24 and 25: ENGLISH 8 CONNECTIONS 24 User’s M
Page 28 and 29: ENGLISH 10 MEASUREMENTS 28 User’s
Page 80 and 81:
ENGLISH 16. TOOLS 80 User’s Manua
Page 82 and 83:
ENGLISH 82 User’s Manual - mediaM
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
ENGLISH 100 User’s Manual - media
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
ENGLISH B/G CCIR STANDARD 122 User
Page 124 and 125:
ENGLISH B/G DE STANDARD 124 User’
Page 126 and 127:
ENGLISH B/G IT STANDARD 126 User’
Page 128 and 129:
ENGLISH L/L’ STANDARD 128 CHAN. I
Page 130 and 131:
Page 132 and 133:
ENGLISH M/N STANDARD 132 User’s M
Page 134:
show all

mediaMAX EVO mediaMAX EVO S2 - FTE Maximal

Create successful ePaper yourself

Delete template?

Save as template?