mediaMAX EVO mediaMAX EVO S2 - FTE Maximal
mediaMAX EVO mediaMAX EVO S2 - FTE Maximal
mediaMAX EVO mediaMAX EVO S2 - FTE Maximal
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ev 2.2<br />
User’s Manual - <strong>mediaMAX</strong> <strong>EVO</strong> - <strong>mediaMAX</strong> <strong>EVO</strong> <strong>S2</strong><br />
10.3.2 Use spectrum mode to spot a signal<br />
To represent the frequency spectrum on the screen and spot a signal, press the “spectrum” key.<br />
When this selection is active, the green led over the key will be switched on.<br />
In case of “tv” and “meter” keys are also switched on, the monitor shows a simultaneous representation<br />
of spectrum, picture and signal measurements. If these options are not necessary at the moment,<br />
it’s possible to switch them off pressing the corresponding keys.<br />
To identify a signal, to do it with a span of 50 MHz is advised (default value in cable). For select it, use<br />
left and right arrows keys. The span current value is shown at the left bottom part of the monitor.<br />
With the spectrum on screen, move the rotary wheel to sweep the frequency band to spot the target<br />
signal. If only spectrum is needed on the monitor, press the buttom “spectrum” to active it. It is possible<br />
also to desactive “tv” and “meter” modes if just spectrum is necessary.<br />
In cable band, “nav” key selects only frequency mode to sweep the band normally by frequency with<br />
100 KHz steps.<br />
10.3.3 Measurement selection<br />
With the target signal identifi ed, it’s necessary to select the signal type (analog or digital). Press “options”<br />
key, select “Carrier mode” and there will be two differents options:<br />
•<br />
•<br />
Analog: if analog signal<br />
Digital: if digital signal<br />
Select one of them and confi rm clicking the wheel.<br />
Reserved of technical modifi cations and/or errors<br />
53<br />
ENGLISH