mediaMAX EVO mediaMAX EVO S2 - FTE Maximal
mediaMAX EVO mediaMAX EVO S2 - FTE Maximal
mediaMAX EVO mediaMAX EVO S2 - FTE Maximal
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ENGLISH<br />
44<br />
User’s Manual - <strong>mediaMAX</strong> <strong>EVO</strong> - <strong>mediaMAX</strong> <strong>EVO</strong> <strong>S2</strong><br />
If “tv” and “spectrum” are selected (the led over these keys are switched on), the monitor shows<br />
a simultaneous representation of measurements, spectrum and picture. If these two options are not<br />
necessary, is possible to cancel their represetantion pressing the corresponding keys.<br />
The meter represents the following digital values:<br />
•<br />
•<br />
•<br />
•<br />
•<br />
•<br />
•<br />
Power<br />
C/N<br />
Noise Margin<br />
BER before Viterbi<br />
BER after Viterbi<br />
MER<br />
Errors<br />
10.2.6 Picture representation<br />
The <strong>mediaMAX</strong> <strong>EVO</strong> meter is equipped with three differents representation modes to show the<br />
information on the screen: “tv”, “spectrum” and “meter”.<br />
There is a led over these buttons that inform the user which options are being currenntly used. At least<br />
one of them will be always switched on.<br />
Their functions could be also combined and based on the measurement type, the information shown<br />
will be different.<br />
Representation possibilities are the following:<br />
1.- “tv” key active. Activates and desactivates the TV monitor mode, showing the image of the selected<br />
signal. In case of digital carriers, this mode will represent the fi rst program of FTA (free to air)<br />
terrestrial multiplex and satellite transponders. If coded signal, the image will not be represented.<br />
Status bar is present for a short period of time; after it will be hidden. To makes it appear again, press<br />
“tv” key.<br />
Reserved of technical modifi cations and/or errors<br />
rev 2.2