7.6.1.0 - Force10 Networks

Force10>show ip prefix detail
Prefix-list with the last deletion/insertion: filter_ospf
ip prefix-list filter_in:
count: 3, range entries: 3, sequences: 5 - 10
seq 5 deny 1.102.0.0/16 le 32 (hit count: 0)
seq 6 deny 2.1.0.0/16 ge 23 (hit count: 0)
seq 10 permit 0.0.0.0/0 le 32 (hit count: 0)
ip prefix-list filter_ospf:
count: 4, range entries: 1, sequences: 5 - 10
seq 5 deny 100.100.1.0/24 (hit count: 0)
seq 6 deny 200.200.1.0/24 (hit count: 0)
seq 7 deny 200.200.2.0/24 (hit count: 0)
seq 10 permit 0.0.0.0/0 le 32 (hit count: 0)
Force10>
Figure 179 show ip prefix-list detail Command Example
Force10>show ip prefix summary
Prefix-list with the last deletion/insertion: filter_ospf
ip prefix-list filter_in:
count: 3, range entries: 3, sequences: 5 - 10
ip prefix-list filter_ospf:
count: 4, range entries: 1, sequences: 5 - 10
Force10>
Figure 180 show ip prefix-list summary Command Example
use a prefix list for route redistribution
To pass traffic through a configured prefix list, you must use the prefix list in a route redistribution
command. The prefix list is applied to all traffic redistributed into the routing process and the traffic is
either forwarded or dropped depending on the criteria and actions specified in the prefix list.
To apply a filter to routes in RIP (RIP is supported on E-Series only.), use either of the following
commands in the ROUTER RIP mode:
Command Syntax Command Mode Purpose
distribute-list prefix-list-name in [interface] ROUTER RIP Apply a configured prefix list to incoming
routes. You can specify an interface.
If you enter the name of a nonexistent
prefix list, all routes are forwarded.
distribute-list prefix-list-name out [interface
| connected | static | ospf]
ROUTER RIP Apply a configured prefix list to outgoing
routes. You can specify an interface or
type of route.
If you enter the name of a non-existent
prefix list, all routes are forwarded.
264 IP Access Control Lists, Prefix Lists, and Route-maps