7.6.1.0 - Force10 Networks

Table 40 SNMP Traps and OIDs
OID String OID Name Description
RPM
.1.3.6.1.4.1.6027.3.1.1.3.8 chRPMMajorAlarmStatus Fault status of the major alarm LED on the
RPM.
.1.3.6.1.4.1.6027.3.1.1.3.9 chRPMMinorAlarmStatus Fault status of the minor alarm LED on the
RPM.
.1.3.6.1.4.1.6027.3.1.1.4.0.11 chAlarmRpmUp Trap generated when the status of primary
or secondary RPM changes to up and
running.
.1.3.6.1.4.1.6027.3.1.1.4.0.12 chAlarmRpmDown Trap generated when the status of primary
or secondary RPM changes to down, either
by software reset or by being physically
removed from the chassis.
Line Card
.1.3.6.1.4.1.6027.3.1.1.2.3.1.15 chSysCardOperStatus Operational status of a line card.
If the chSysCardAdminStatus is “up”, the
valid state is “ready”, that is, the card is
present and ready, and the
chSysCardOperStatus status is “up.”
If the chSysCardAdminStatus is “down”,
the service states can be:
• offline—the card is not used.
• cardNotmatch—the card does not
matched what is configured.
• cardProblem—a hardware problem is
detected on the card.
• diagMode—the card is in diagnostic
mode.
.1.3.6.1.4.1.6027.3.1.1.2.3.1.16 chSysCardFaultStatus Fault status of the card:
• on—the system fault light is on
• off—the system fault light is off
.1.3.6.1.4.1.6027.3.1.1.4.0.1 chAlarmCardDown Trap reported when the card operational
status changes to down.
.1.3.6.1.4.1.6027.3.1.1.4.0.2 chAlarmCardUp Trap reported when the card operational
status changes to up.
.1.3.6.1.4.1.6027.3.1.1.4.0.3 chAlarmCardReset Trap reported when a card is reset.
.1.3.6.1.4.1.6027.3.1.1.4.0.7 chAlarmCardProblem Trap reported when the card operational
status changes to "card problem."
SFM
422 SNMP Traps