7.6.1.0 - Force10 Networks

• rate limit for outgoing traffic on page 282
• limit or suppress traffic on page 284
• rate shape of outgoing traffic on page 283
set dot1p priorities for incoming traffic
To assign a value for the IEEE 802.1p bits on traffic received on an interface, use this command:
Command Syntax
Command
Mode
Figure 193 illustrates how to configure a dot1p-priority:
Usage
dot1p-priority priority-value INTERFACE The dot1p-priority command changes the priority of
incoming traffic on the interface. FTOS places traffic
marked with a priority in the correct queue and processes
that traffic according to its queue.
When you set the priority for a port channel, the physical
interfaces assigned to the port channel are configured
with the same value. You cannot assign the dot1p-priority
command to individual interfaces in a port channel. Refer
to Table 28 for more information about entering
dot1p-priority values.
FTOS Behavior: The C-Series and S-Series distribute eight dot1p priorities across four data queues.
This is different from the E-Series, which distributes eight dot1p priorities across eight queues
(Table 28).
Table 28 dot1p-priority values and queue numbers
dot1p
E-Series Queue
Number
C-Series Queue
Number
0 2 1 1
1 0 1 1
2 1 0 0
3 3 0 0
4 4 2 2
5 5 2 2
6 6 3 3
7 7 3 3
S-Series Queue
Number
280 Quality of Service