7.6.1.0 - Force10 Networks

To view the configuration, use the show config command in the ROUTE-MAP mode (Figure 185).
Force10(config-route-map)#show config
!
route-map dilling permit 10
Force10(config-route-map)#
Figure 185 show config Command Example in the ROUTE-MAP Mode
You can create multiple instances of this route map by using the sequence number option to place the route
maps in the correct order. FTOS processes the route maps with the lowest sequence number first. When a
configured route map is applied to a command, like redistribute, traffic passes through all instances of
that route map until a match is found.
Figure 186 shows an example with two instances of a route map.
Force10#show route-map
route-map zakho, permit, sequence 10
Match clauses:
Set clauses:
route-map zakho, permit, sequence 20
Match clauses:
interface GigabitEthernet 0/1
Set clauses:
tag 35
level stub-area
Force10#
Figure 186 show route-map Command Example with Multiple Instances of a Route Map
To delete all instances of that route map, use the no route-map map-name command. To delete just one
instance, add the sequence number to the command syntax (Figure 187).
Force10(conf)#no route-map zakho 10
Force10(conf)#end
Force10#show route-map
route-map zakho, permit, sequence 20
Match clauses:
interface GigabitEthernet 0/1
Set clauses:
tag 35
level stub-area
Force10#
Figure 187 Example of Deleting One Instance of a Route Map
Route map zakho has two
instances
Figure 188 shows an example of a route map with multiple instances. The show config command
displays only the configuration of the current route map instance. To view all instances of a specific route
map, use the show route-map command.
FTOS Configuration Guide, version 7.6.1.0 271